Bedienungsanleitung Stihl FB131 (Seite 9 von 80) (Englisch, Spanisch)

667512

Zoom out

Zoom in

Vorherige Seite

1/80

Nächste Seite

FB 131

English

WARNING

The cutting attachment and deflector

must be properly tightened and in safe

operating condition. Inspect for loose

parts (nuts, screws, etc.) and for

cracked, bent, warped or damaged

blades. Replace a damaged blade or

deflector before using the power tool.

Keep the handles clean and dry at all

times; it is particularly important to keep

them free of moisture, pitch, oil, fuel mix,

grease or resin in order for you to

maintain a firm grip and properly control

your power tool.

WARNING

Check that the spark plug boot is

securely mounted on the spark plug – a

loose boot may cause arcing that could

ignite combustible fumes and cause a

fire.

WARNING

An arrow on the deflector shows the

correct direction of rotation of the cutting

blade.

The arrow on the deflector must always

face away from you, so that cuttings and

other debris will be diverted away from

the machine and your position (see

chapter "Working Techniques".)

For proper control and less fatigue

during operation, adjust the loop handle

to suit your size before starting work.

Starting

WARNING

To reduce the risk of serious personal

injury from fire, start the engine at least

10 feet (3 m) from the fueling spot,

outdoors only.

For specific starting instructions, see the

appropriate section of your manual.

Place the power tool on firm ground or

other solid surface in an open area.

Maintain good balance and secure

footing.

WARNING

To reduce the risk of injury from blade

contact, be absolutely sure that the

cutting attachment is clear of you and all

other obstructions and objects, including

the ground, because when the engine

starts at starting-throttle, engine speed

will be fast enough for the clutch to

engage and move the cutting

attachment.

Once the engine has started,

immediately blip the throttle trigger,

which should release the starting throttle

and allow the engine to slow down to

idle.

WARNING

Your power tool is a one-person

machine. Do not allow other persons in

the general work area, even when

starting.

WARNING

To reduce the risk of injury from loss of

control, do not attempt to "drop start"

your power tool. Drop starting means

pushing the machine away from the

operator, or allowing it to drop toward

the ground, while pulling on the starter

grip. This method is very dangerous

bescause you may lose control of the

machine.

WARNING

When you pull the starter grip, do not

wrap the starter rope around your hand.

Do not let the grip snap back, but guide

the starter rope to permit the rope to

rewind properly. Failure to follow this

procedure may result in injury to your

hand or fingers and may damage the

starter mechanism.

To reduce the risk

of personal injury

to the operator

from blade con-

tact and thrown

objects, make sure

your unit is

equipped with the

proper deflector,

skirt and handle.

9924BA001 KN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stihl FB131 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info