Bedienungsanleitung Stihl FS 90 (Seite 17 von 116) (Englisch, Spanisch)

537272

Zoom out

Zoom in

Vorherige Seite

1/116

Nächste Seite

FS 90, FS 90 R

English

replaced by the special limit stop

deflector (see chapter on "Mounting the

Deflector"). This limit stop helps to keep

the unit positioned against the tree

during the cutting process.

Inexperienced users should place the

left side of the stop against the tree trunk

before beginning to cut. This will keep

the trimmer / brushcutter against the tree

during the cutting operation and will

reduce the risk of loss of control and

possible kickout (described above and

briefly again below).

Before starting the cut, accelerate the

engine up to full throttle. Perform cut

with uniform pressure. STIHL

recommends that the circular saw blade

be applied to the right of the tree, using

the non-shaded area of the blade, as

shown in the illustration above.

WARNING

The risk of kickout is highest when

cutting in the darker shaded area. To

reduce the risk of kickout and resulting

injury, do not use this area of the circular

saw blade for cutting trees or shrubs.

Special techniques using the lighter

shaded areas of the blade to cut shrubs

and trees should only be used by

experienced operators with specialized

training in the use and control of the

trimmer / brushcutter.

WARNING

To reduce the risk of loss of control and

serious injury to the operator or

bystanders by a kickout, never use a

circular saw blade on a trimmer /

brushcutter with a loop handle, but

rather only on one with a bicycle handle.

When felling small trees, maintain a

distance of at least two tree lengths from

the nearest coworker.

WARNING

In order to reduce the risk of injury from

thrown objects or operator contact with

the blade or head, be sure to remount

the standard deflector when no longer

using a circular saw blade.

MAINTENANCE, REPAIR AND

STORING

Maintenance, replacement, or repair of

the emission control devices and

systems may be performed by any

nonroad engine repair establishment or

individual. However, if you make a

warranty claim for a component which

has not been serviced or maintained

properly or if nonapproved replacement

parts were used, STIHL may deny

coverage.

WARNING

Use only identical STIHL replacement

parts for maintenance and repair. Use of

non-STIHL parts may cause serious or

fatal injury.

Strictly follow the maintenance and

repair instructions in the appropriate

sections of your instruction manual.

WARNING

Always stop the engine and make sure

that the cutting attachment is stopped

before doing any maintenance or repair

work or cleaning the power tool. Do not

attempt any maintenance or repair work

not described in your instruction manual.

Have such work performed by your

STIHL servicing dealer only.

Wear gloves when handling or

performing maintenance on blades.

WARNING

Use the specified spark plug, and make

sure it and the ignition lead are always

clean and in good condition. Always

press the spark plug boot snugly onto

002BA214 ST

002BA068 KN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stihl FS 90 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Stihl FS 90

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info