667232
43
Zoom out
Zoom in
Vorherige Seite
1/136
Nächste Seite
0458-713-9621-B
41
English
7 Assembling the Trimmer
Insert the plug (6) in a convenient wall outlet (7).
The charger (3) runs a self test. The LED (4) glows green
for about 1 second and then red for about 1 second.
Lay the connecting cable (5).
Insert the battery (2) in the guides in the charger (3) and
press it home as far as stop.
The LED (4) glows green. The LEDs (1) glow green and
the battery (2) is being charged.
If the LED (4) and the LEDs (1) stop glowing: Disconnect
the plug (6) from the wall outlet (7).
Battery is fully charged.
Remove the battery (2).
6.2 State of Charge
Press the button (1).
The LEDs (5) glow green for about 5 seconds and indicate
the state of charge.
If the LED on the right flashes green: Charge the battery.
6.3 LEDs on Battery
The LEDs can show the state of charge or malfunctions. The
LEDs can glow or flash green or red.
The state of charge is indicated when the LEDs glow or flash
green.
If the LEDs glow or flash red: Troubleshooting, @ 18.
Malfunction in trimmer or battery.
6.4 LED on Charger
The LED indicates the operating status of the charger.
If the LED glows green, the battery is being charged.
If the LED flashes red: Rectify the malfunction.
Malfunction in charger.
7.1 Mounting Deflector for Mowing Heads
Switch off the trimmer and remove the battery.
The line limiter blade (1) is already installed in the deflector
(2) and must not be removed.
Push the deflector (2) into the guides on the housing as far
as stop.
The deflector (2) is tight against the housing.
Insert and tighten down the screws (3).
The deflector (2) must not be removed again.
7.2 STIHL AutoCut 2-2 Mowing Head
7.2.1 Installing the Spool
Switch off the trimmer and remove the battery.
If a spool has already been in use, place it in a container
filled with water for 12 to 24 hours before installing.
This makes the nylon mowing lines supple.
7 Assembling the Trimmer
1
3
2 2
0000-GXX-1486-A1
43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

stihl-fsa-56

Suche zurücksetzen

  • Antrieb ist blockiert. Mähfaden um antriebswelle gewickelt Eingereicht am 7-5-2020 13:34

    Antworten Frage melden
  • Wie wechselt man den Mähfaden auf eine leere Mähkopfspule?
    Eingereicht am 11-5-2019 15:23

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Stihl FSA 56 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info