Bedienungsanleitung Stihl SR 200 (Seite 10 von 84) (Englisch, Spanisch)

537348

Zoom out

Zoom in

Vorherige Seite

1/84

Nächste Seite

SR 200

English

solution to reduce the risk of backflow,

i.e. the chemicals being sucked into the

water supply in the case of a sudden

vacuum.

Calculate the correct amount of

chemical solution so that it is used up at

one time, with no extra solution left in the

tank.

After filling, fit the container cap and

tighten it down firmly.

WARNING

Check for leakage while refilling and

during operation. A leak from the

container or a loose fitting could soak

your clothing and come into contact with

your skin.

Before Starting

WARNING

Always check your power tool for proper

condition and operation before starting,

particularly the throttle trigger and

setting lever with stop position. The

throttle trigger must move freely and

always spring back to the idle position.

Never attempt to modify the controls or

safety devices.

WARNING

Check fuel system for leaks, especially

the visible parts, e.g., filler cap, hose

connections, manual fuel pump (only for

power tools equipped with a manual fuel

pump). Do not start the engine if there

are leaks or damage – risk of fire! Have

the machine repaired by a servicing

dealer before using it.

WARNING

To reduce the risk of leakage and skin

contact with chemicals, check that the

container cap and all connections in the

path of the spray are tight, and be sure

the hose is securely attached and in

good condition. Keep the valve lever

closed.

WARNING

Never operate your power tool if it is

damaged, improperly adjusted or

maintained, or not completely or

securely assembled.

WARNING

Check that the spark plug boot is

securely mounted on the spark plug – a

loose boot may cause arcing that could

ignite combustible fumes and cause a

fire.

Keep the control handle clean and dry at

all times; it is particularly important to

keep it free of moisture, pitch, oil, fuel

mix, grease or resin in order for you to

maintain a firm grip and properly control

your power tool.

WARNING

To reduce the risk of injury from thrown

parts, check the fan housing for damage

(cracks, nicks, chipping). If any damage

is found, stop using the unit and contact

your STIHL dealer for repair.

Check condition of harness straps and

replace damaged or worn straps.

WARNING

Adjust carrying harness to suit your size

before starting work.

In an emergency, you may slip out of the

harness and throw off the machine

quickly. Try slipping out of the harness a

number of times before using the

machine in order to become

accustomed to it. Do not throw off the

machine while practicing as it could

damage the machine.

Starting

Start the engine at least 10 feet (3 m)

from the fueling spot, outdoors only.

For specific starting instructions, see the

appropriate section in this instruction

manual. Place the power tool on firm

ground or other solid surface in an open

area. Maintain good balance and secure

footing.

WARNING

Your power tool is a one-person

machine. To reduce the risk of eye or

other injury from thrown objects, insure

that bystanders are at least 50 feet

(15 m) away when starting and during

use. Stop operation immediately if you

are approached.

271BA003 KN

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stihl SR 200 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Stihl SR 200

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info