Bedienungsanleitung Stihl SR 450 (Seite 11 von 100) (Englisch, Spanisch)

537350

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

SR 430, SR 450

English

The bayonet fuel filler cap must be

closed with care after refuelling.

Screw Cap

WARNING

Filling the Container

WARNING

Tighten all connections and check to be

sure the hose is securely attached and

in good condition. Keep the valve lever

on the control lever closed.

Before using the power tool with

chemicals, fill it with fresh water to

assure that you have it properly

assembled and practice spraying. Also,

check for any leaks at this time. When

thoroughly familiar with the power tool

operation, follow normal operating

procedures.

Fill your power tool in well-ventilated

areas, outdoors.

WARNING

Do not use:

– flammables in the mistblower, which

can explode causing serious or fatal

injury;

– caustic or corrosive materials in the

mistblower, that could result in

damage to the unit;

– liquids with a temperature above

120° F (50° C) to avoid scalding and

damage to the unit.

To fill the container, place the power tool

on a level surface. To reduce the risk of

contaminating the surrounding

environment, be careful not to overfill the

container with chemical solution.

To reduce the risk of injury, do not fill the

unit while wearing it on your back.

If you fill the container with a hose

attached to a central water supply, be

sure the end of the hose is out of the

solution to reduce the risk of backflow,

i.e. the chemicals being sucked into the

water supply in the case of a sudden

vacuum.

Calculate the correct amount of

chemical solution so that it is used up at

one time, with no extra solution left in the

tank.

After filling, fit the container cap and

tighten it down firmly.

WARNING

Check for leakage while refilling and

during operation. A leak from the

container or a loose fitting could soak

your clothing and come into contact with

your skin.

Before Starting

WARNING

Always check your power tool for proper

condition and operation before starting,

particularly the throttle trigger and

setting lever with stop position. The

throttle trigger must move freely and

always spring back to the idle position.

Never attempt to modify the controls or

safety devices.

WARNING

Check fuel system for leaks, especially

the visible parts, e.g., filler cap, hose

connections, manual fuel pump (only for

power tools equipped with a manual fuel

pump). Do not start the engine if there

are leaks or damage – risk of fire! Have

the machine repaired by a servicing

dealer before using it.

WARNING

To reduce the risk of leakage and skin

contact with chemicals, check that the

container cap and all connections in the

path of the spray are tight, and be sure

the hose is securely attached and in

good condition. Keep the valve lever

closed.

WARNING

Never operate your power tool if it is

damaged, improperly adjusted or

maintained, or not completely or

securely assembled.

Unit vibrations can cause

an improperly tightened

fuel filler cap to loosen or

come off and spill quanti

ties of fuel. In order to

reduce the risk of fuel

spillage and fire, tighten

the fuel filler cap by hand

as securely as possible.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stihl SR 450 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Stihl SR 450

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info