Bedienungsanleitung Stovax Studio (Seite 11 von 36) (Englisch, Französisch, Italienisch)

813436

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

LEGAL REQUIREMENTS

Before installation and/or use of this appliance please read these

instructions carefully to ensure that all requirements are fully

understood.

The appliance must be fitted by a registered installer, or

approved by your local building control officer.

It is very important to understand the requirements of the

national Building Regulations and standards, along with any local

regulations and working practices that may apply. Should any

conflict occur between these instructions and these regulations

then the regulations must apply.

Your local Building Control Office can advise regarding the

requirements of the regulations.

HEALTH AND SAFETY PRECAUTIONS

Works must be carried out with care to meet the requirements of

Health and Safety and comply with the Health and Safety rules,

and any new regulations introduced during the lifetime of these

instructions. Particular attention should be drawn to:

— Handling: The appliance is heavy. Adequate facilities must be

available for loading, unloading and on site handling.

— Fire Cement: Some fire cement is caustic and must not come

into contact with the skin. Protective gloves must be worn.

Wash hands thoroughly with plenty of water after contact with

skin.

— Asbestos: This appliance contains no asbestos. If there is

the possibility of disturbing any asbestos in the course of

installation seek specialist guidance and use appropriate

equipment.

— Metal Parts: Take care when installing or servicing the stove to

avoid personal injury.

A faulty installation can cause danger to the inhabitants and

structure of the building.

For users of this appliance:

Your building insurance company may require you to inform them

that a new heating appliance has been installed on your property.

Check that your cover is still valid after installing the appliance.

Combustion Air Supply:

This appliance requires a constant supply of air to maintain proper

combustion and effective flue performance.

An inadequate air supply can result in poor combustion and smoke

entering the room which is potentially dangerous.

This supply of air can come from either:

— Purpose provided ventilation.

— Some Stovax appliances can also be fitted with an

optional outdoor air kit which allows air to be drawn in

from the outside.

The amount of air required must comply with local building

regulations and the rules in force.

If spillage is detected during commissioning then there may be

insufficient natural ventilation and an additional air supply will be

necessary.

Permanent air vents should be non-adjustable and positioned

where they are unlikely to be become blocked.

Extractor fans or cooker hoods must not be placed in the same

room or space as this can cause the appliance to emit fumes into

the room.

Aerosol Sprays

Do not use an aerosol spray on or near the appliance when it

is alight.

Combustible Materials in the home

Do not place photographs, TV’s, paintings, porcelain or other

combustible items on the wall or near the appliance. Exposure

to hot temperatures will cause damage. Do not place furniture

or other items such as drying clothing closer than 1m from the

front of this appliance.

WARNING: Extra fuel should not be stored on or next to the

appliance. Only keep enough fuel for immediate use nearby

and never leave the appliance unattended for long periods with

any combustible material in close proximity.

HEARTHS

The appliance must stand on a non-combustible constructional

hearth in accordance with Approved Document J.

As this appliance can be installed in an elevated setting it is

recommended to increase the 225mm hearth depth to safely

contain any falling logs or embers. The higher the appliance is

installed the deeper the hearth should be to protect the floor.

The building must have a suitable load-bearing capacity for the

hearth and appliance. Consult a structural engineer for advice

before proceeding.

Some houses are built using a timber frame construction with high

levels of thermal insulation. Isolate the appliance from combustible

materials, and provide sufficient ventilation to maintain the heating

efficiency.

COMMISSIONING AND HANDOVER

Ensure all parts are fitted in accordance with the instructions.

On completion of the installation allow a suitable period of time for

any fire cement and mortar to dry out, before lighting the stove.

Once the appliance is operating check all seals for soundness and

check that the flue is functioning correctly and that all products

of combustion are vented safely to atmosphere via the chimney

terminal.

On completion of the installation and commissioning ensure

that the operating instructions for the appliance are left with the

customer. Ensure to advise the customer on the correct usage and

warn them to use only the recommended fuel for the appliance.

Advise the user what to do should smoke or fumes be emitted from

the appliance.

The customer should be warned to use a fireguard to BS

8423:2002 in the presence of children, aged and/or infirm persons.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stovax Studio Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Stovax Studio

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info