Bedienungsanleitung Stovax View 7 Inset High Output Boiler Inset (Seite 6 von 44) (Englisch)

813428

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

SAFETY CONTROLS

1.20 A high limit thermostat is fitted to the gravity flow pipe set at

80˚C.Thisthermostatshouldbeconnectedtothepumpso

thatthepumpisturnedonifthetemperatureexceeds80˚C.

This will prevent accidental boiling in the gravity circuit.

1.21 It is also recommended to fit a low limit thermostat on the

centralheatingreturnsetat45˚C.Thisthermostatwillturnthe

pumpoffifthereturntemperaturefallsbelow45˚C.Thiswill

prevent corrosion and condensation within the appliance.

NOTE – Further information on solid fuel central heating

systems can be found in the HETAS engineers training manual.

WARNING

Properly installed, operated and maintained, this

appliance will not emit fumes into the room.

Occasional fumes from de-ashing and refuelling

may occur.

Persistent fume emission is potentially

dangerous and must not be tolerated.

If fume emission does persist:

• Open doors and windows to ventilate the room.

• Leave the room.

• Allow fire to burn out and safely dispose of

fuel from the appliance.

• Check for chimney blockage and clean if

required.

• Do not attempt to relight until the cause of the

emission has been identified and corrected

• If necessary seek expert advice.

• All open flued appliances can be affected by

temporary atmospheric conditions which may

allow fumes to enter the house. Because of

this an electronic carbon monoxide detector

conforming to the latest edition of BSEN50292

must be fitted in the same room as the

appliance. The existence of an alarm must not

be considered a substitute for ensuring regular

servicing and maintenance of the appliance and

chimney system.

IF THE ALARM SOUNDS FOLLOW THE

INSTRUCTIONS GIVEN ABOVE.

Getting Started

2. Using the Appliance for the First Time

2.1 To allow the appliance to settle, and fixing glues and paint

to fully cure, operate the appliance at a low temperature for

first few days.

2.2 Do not touch the paint during the first period of use.

2.3 During this time the appliance may give off some unpleasant

odours. Keep the room well ventilated to avoid a build-up of

fumes.

2.4 Please be aware that, during use, rope seals may discolour.

This is normal.

CONDENSATION

CAUTION WHEN FILLING

2.5 When filling the boiler with water for the first time, the cold

water entering the water jacket can cause condensation to

form on the surfaces of the appliance (inside and outside).

2.6 In certain conditions this condensation could result in a

considerable amount of water, in some cases enough to fill

the bottom of the appliance. This could be even worse if the

house has recently been re-decorated, wet plastered or any

other work has been undertaken which could result in high

humidity.

2.7 Precautions must be taken to ensure that this build up of

condensate does not overflow from the appliance onto any

surrounding fabric of the room e.g. carpets.

NOTE - THIS CONDENSATION IS NORMAL DURING

FILLING AND DOES NOT INDICATE A FAULTY OR

LEAKING APPLIANCE.

NORMAL RUNNING

2.8 During normal running this condensation should be minimal

if the system is fitted with the low limit thermostat as detailed

in 1.21. This low limit thermostat prevents the system pump

from running until the appliance has reached temperature.

SEASONAL USE

2.9 If this appliance is unused for lengthy periods of time it

should be periodically checked to ensure that condensation

is not building up within the appliance.

NOTE – THIS CONDENSATION IS NORMAL AND DOES

NOT INDICATE A FAULTY OR LEAKING APPLIANCE.

If the appliance is going to be unused for very long periods

of time it is recommended to drain the system.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stovax View 7 Inset High Output Boiler Inset Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info