Bedienungsanleitung Stoves SDF60DO (Seite 35 von 40) (Englisch)

659745

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

INSTALLATION INSTRUCTIONS - DUAL FUEL

CONNECT TO THE GAS SUPPLY

The inlet to the cooker is ½” BSP inter-

nal situated at the rear right corner. Fit

the bayonet connection. This should be

locatedsoastoensurethattheexible

connector hose does not kink.

Undernocircumstancesshouldtheex-

ible connector be allowed to come into

contactwiththeverticalovenuetubes

on the rear of the appliance.

Usea900mm-1125mmlengthofexible

connector.

Ensure that all pipework is of the correct

rating for both size and temperature.

Natural Gas - Flexible connections should

comply with BS 669. Parts of the appli-

ance likely to come into contact with a

exibleconnectorhaveatemperaturerise

of less than 70°C.

After installation, make sure all connec-

tions are gas sound.

COMMISSIONING

Burner aeration

Allburnershavexedaerationandno

adjustment is possible.

Hob burner

Turn the control knob to the FULL ON

position, wait a second before pressing

the ignition switch or holding a lighted

match or taper to the burner. Hold the

control knob in for 15 seconds. Do not

hold the control knob in for longer that 15

seconds. If the burner fails to light within

this time, release the control knob and

wait one minute before attempting further

ignition.

Check the operation of electrical compo-

nents, viz;

Clock programmer/ Minute minder

Check functions as described earlier in

this booklet.

Oven light & convection fan

Open the main oven door. Turn the main

oven control knob to the defrost setting

. , check the oven light and convection

fan both come on. Turn control knob back

to off position.

Cooling fan

Open the grill door. Turn the grill control

knob to the full power setting . Check

that the cooling fan operates. Turn

control knob back to off position and

check cooling fan switches off immedi-

ately.

Lid safety system (if tted)

Ignite all hotplate burners including wok.

Attempt to close the lid and make sure

allamesareextinguishedbythesafety

system.

Ifyouaresatisedthatthecookerisop-

erating correctly, turn it off and show the

customer how to use it. Make sure you

ask the customer to operate the clock (if

tted)andcontrols.

Explain to the user that the lid safety

system must not be used as a means of

turning off the hotplate burners. Control

knobs must always be turned to the off

position after use.

Note- If the cooker does not perform cor-

rectly, inform the customer of the problem

and put a warning notice on the cooker. If

the problem is dangerous, then discon-

nect the cooker. If there is a fault, then

the customer should be advised to contact

the manufacturer’s local service organisa-

tion or the retailer.

Before leaving the installation hand

over the handbook to the customer.

Thank you.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stoves SDF60DO Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info