PART 3 • English
76
A.1 Trouble Shooting
Occasionally receivers can hang-up (just like with a PC) so you are recommended to reset
the receiver by disconnecting it from mains power. Wait 30 seconds and connect to mains
power again and now check if the unit is working as expected. If the receiver does not
work properly after checking the trouble shooting section, please contact the dealer. Don’t
open the receiver cover, it may cause an electrical shock due to high current voltage and
the warranty of your receiver will be void if the receiver has been opened.
Symptoms
No green/red lights on
No picture and sound
No picture and sound
No picture and sound
No sound
No sound or picture
Cause
The power cord is not
plugged in
TV is set to wrong
channel
Problem in cable
connections between
receiver and TV
Receiver “hang-up”
The receiver or TV is in
“MUTE” mode
Problem in scart cable
connections between
receiver and TV
Solution
Check that the power cord is plugged
into the wall outlet
Check if the TV is switched on and set
your TV to the correct EXT / AV
channel
Check if the scart and/or RF cable is
connected correctly to the TV and to
the back of the receiver
Switch off receiver; disconnect the
main power cord of the receiver from
the 220V main power. After 30 seconds
reconnect to the main power and check
if it is working properly
Press the MUTE button on the remote
control unit of your receiver and TV
Firmly press the scart connectors on
the backside of the TV and receiver.
Replace the scart cable
