Bedienungsanleitung Strong SRT 7000 (Seite 9 von 25) (Englisch)

480531

Zoom out

Zoom in

Vorherige Seite

1/25

Nächste Seite

PART 1 • English

4.0 FIRST TIME INSTALLATION

After all connections have been made properly, switch on TV and make sure the receiver is connected

to the main power. Then switch on the receiver. If you are using the receiver for the ﬁrst time or restored

to factory default, the First Installation menu will appear on your TV screen. Use tu buttons to select

the OSD Language of your preference and press OK to conﬁrm. An Info page will be displayed. Read the

guide info and press the INFO button to proceed to the next Installation step. You can open and close the

info page again by using the INFO button.

NOTE: If German is conﬁrmed as language, German preset channels from ASTRA 19.2E will

be installed. You can continue with the Installation menu to scan and install further

channels like described below or quit it by double pressing the EXIT button and enjoy

the pre-installed channels.

4.1 Installation

Satellite Selection

use pq to highlight the satellite your dish is aimed at. When using a multi feed antenna with more than

1 LNB, select the satellites your antenna is adjusted for by OK button and set the appropriate LNB´s in

the DiSEqC point. The scan process will be done then on all selected satellites.

Signal Adjust

the signal quality bar on the bottom of the screen allows you to ﬁne tune the alignment of your antenna

for optimum reception. Adjust your antenna for maximum possible signal quality. Once the signal cannot

be improved anymore, ﬁx the dish on this position and press the BLUE button for Scan.

Scan Mode

use pqtu to highlight the desired options and press OK to start the Channel Search. Default settings

are recommended.

Channel Search

your receiver will now perform an automatic channel search. Once the process is ﬁnished, all found

channels will be stored and the receiver will switch to the ﬁrst found channel. You are now ready to enjoy

your new receiver.

NOTE: If no channels were found during the automatic channel scan, the receiver will return to

the First Installation menu. Please select your language again and refer to chapter 7.3.

for further instructions.

5.0 QUICK GUIDE TO USING YOUR RECEIVER

We at STRONG understand that you can’t wait to enjoy your new HD receiver. The following quick guide

will make you familiar with the basic operation of this device. We do, however, advice you to read the full

manual to get the best performance from your STRONG HD receiver.

To turn your receiver ON or to Standby, use the STANDBY button on the remote control or the button on

the left side of the front panel.

Choose the desired channel with the pq buttons. Alternatively, you can digit the channel number with

the 0~9 buttons on the remote control. Or press OK in viewing mode to display the channel list.

The volume can be adjusted with the tu buttons.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Strong SRT 7000 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info