751652
26
Zoom out
Zoom in
Vorherige Seite
1/32
Nächste Seite
Pictures:
UP/DOWN: Enter the folder with pictures les. Use the pq to select a picture. If format is
supported then in the small PIP screen it shows the picture. Press OK button to watch
it in full screen mode.
RED Interval: Before the playback of a picture in full screen, you can setup a slideshow / diashow.
Press the Red button Interval to enter the sub option menu Select time interval. Select
time of the slide show or switch this function o. After you select a time, press OK and
show starts to play. Press the button to stop.
7.4.2 DVR setup
This menu allows you to setup settings for Timeshift functions, DVR Timer start and stop handlings.
The following settings are available:
Timeshift Status: Choose Enable to activate the Timeshift function and Record DVR function
will be switched O.
Choose Disable to deactivate the Timeshift function and Record PVR function
will be switched On.
Timeshift Step: Use the 0~9 buttons to enter the time steps in playback
Timeshift Duration: Use the 0~9 buttons to enter the total time space you would like to use on
the external connected USB device.
Start record earlier: Select a time to start record earlier as programmed. This is a nice function if
you booked events directly from EPG which can be sometimes wrong in time,
due to actuallities.
End record later: Select a time to stop the record later as programmed.
REC Icon: Select between 5Sec 5 seconds or 10 Sec 10 seconds to show the record Icon
on screen after you start record. Select On for always show the Icon during the
record.
Playback Repeat: Select between On to start over again playback of record you watching. Select
O to stop normal at the end.
7.4.3 Storage Device Setup
This option shows relevant information about the connected USB device. In this menu you can also
format your USB storage device and safely remove.
Select Storage Device Setup in the Storage menu and press OK to enter.
All details as free and used space sizes and used le system are shown.
Press the Red Safely Remove button and press OK to safely disconnect the USB device. The receiver will
display a message indicating that you can now safely remove your storage device from the receiver.
Press the Blue Format USB Device button to format the connected USB device.
Please, enter your PIN code to access the menu and press OK to start formatting.
Press to leave this menu.
NOTE: After performing the Safely Remove function, the USB device is no longer
accessible by your receiver. To gain access to your storage device again,
re-insert it or switch the receiver to standby and on-mode again.
22
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Strong SRT 7502 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info