Bedienungsanleitung Strong SRT 8113 (Seite 11 von 26) (Englisch)

568533

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite







Antenna Power: Set to On if you use an active antenna. When set to On, 5 V will be present

on the ANT IN connector of the receiver. Select Off for passive antennas. The

included antenna is a active type. If you using this antenna keep it selection

to On.

 Wrong region selection can lead to missing channels or channels being

stored on wrong positions in the channel list. All default selections above are

most common to use.

Once all settings are made, move the highlight to OK press  to start scanning.

The receiver will now search for all available channels. Once scanning is finished, the receiver switches

to viewing mode.

 If the Welcome “Easy install” menu does not appear after switching on the

receiver the first time, reset the receiver to factory settings by pressing the

 button and selecting Factory Setting in the submenu Tools. (





We at STRONG understand that you can’t wait to enjoy your new high definition digital terrestrial

receiver. The following quick guide will make you familiar with the basic operation of this device. We

do, however, advice you to read the full manual to get the best performance from your receiver.

To turn your receiver ON or to Standby, use the q button on the remote control.

Choose the desired channel with the p q buttons. Alternatively, you can digit the channel number

with the  buttons on the remote control. Or press  in viewing mode to display the channel list.

The volume can be adjusted with the t u buttons.



Your new receiver is equipped with several features to make watching TV a true pleasure. This

paragraph describes these features. Please also read chapter  to get familiar with the menu of your

receiver.



Your new receiver is equipped with four ways to change channels.

 Via direct access using the  buttons.

 Via the channel list trough  button.

 Via the  and  keys.

 Via the p q keys.



To gain direct access to a certain channel, simply input its number with the  buttons on the

remote control. Channel numbers can be up to four digits long. Entering a number with less than

four digits is possible. Just wait a few seconds and your receiver will switch to the selected channel or

press  immediately after selecting the channel number.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Strong SRT 8113 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info