Bedienungsanleitung Strong SRT 8203 (Seite 13 von 37) (Englisch)

751657

Zoom out

Zoom in

Vorherige Seite

1/37

Nächste Seite

English

«VIDEO», «INPUT», «Source» or with the symbol . If you have selected correct input, then

you will see on the on-screen of the receiver named «Init Install».

NOTE: Depending from brand and model of your TV, the name of the HDMI input

can be different, for example: HDMI1, HDMI2.

Select OSD Language. Press OK or u to start language selection.

Select Country and press OK or u to select the country of your residence.

Select LCN and press OK or u to select if the channel numbering should be according to LCN (as defined

by operator) or not.

Select Next and press OK or u to go to Antenna Setup menu.

This part of the wizard is of great help when setting up your antenna system.

Use pq to move the highlight to the setting you wish to alter and use OK or u to change values.

The following settings are available:

Active Antenna: Before connecting your antenna to the receiver, please read the user manual of your

antenna regarding antenna powering. This parameter is recommended to set to

On only for active internal or external antennas which require power supply via an

antenna cable with voltage of 5 V DC and consume less than 50 mA. In all other cases

please leave this parameter as Off.

Country Select the country of your residence.

Beep: Select On for an audible indication of signal reception. Off (default) turns the beeper

off.

Channel No.: Select a channel that is known to carry a broadcast in your region. The Signal Strength

and Signal Quality bars give a visual indication of the reception. Adjust your antenna

to obtain maximum signal strength and quality.

Frequency: Reference information about frequency for the selected frequency channel. Parameter

could be defined manually if you prefer to adjust antenna by frequency.

Bandwidth: Reference information about bandwidth for the selected frequency channel.

Parameter could be defined manually if you prefer to adjust antenna by frequency/

bandwidth parameters.

When all settings have been made, select Start Search and press OK or u to start scanning.

The receiver will search for all available channels now.

Once scanning is finished, the receiver switches to viewing mode.

You are now ready to watch TV.

5.0 QUICK GUIDE TO USING YOUR RECEIVER

We at STRONG understand that you can’t wait to enjoy your new digital terrestrial receiver.

The following chapter will make you familiar with the basic operation of this device.

We do, however, advice you to read all chapters of this manual to get the best performance from your

receiver.

To turn your receiver ON or to Standby, use the q button on the remote control.

Choose a channel with pq (CH+/CH-) on the RCU. Alternatively, you can enter the channel number

with 0-9 buttons on the RCU or press OK in viewing mode to display the channel list.

The volume can be adjusted with t/u (VOL-/VOL+).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Strong SRT 8203 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info