Bedienungsanleitung Strong SRT 8550 (Seite 24 von 28) (Englisch)

751661

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Start Record earlier:

If you want to start the recording, set under timer from EPG some minutes earlier than

the time obtained from the programme guide.

End Record later: If you want to stop the recording, set under timer from EPG some minutes later as time

obtained from the programme guide.

REC Icon: If you start a recording, an icon will be shown in the left upper corner of your TV screen

with the text “REC”. Default is set to On. Select 5 Seconds or 10 Seconds to let the icon

disappear after the selected time.

1.31.3 Storage Device Setup

This option shows relevant information about the connected USB device. In this menu you can also

format your USB storage device and safely remove.

Select Storage Device Setup in the Multimedia menu and press OK to enter.

Now you will see all details as free and used space sizes and used le system.

Press the RED Safely Remove button and press OK to safely disconnect the USB device. The receiver will

display a message indicating that you can now safely remove your storage device from the receiver.

Press the BLUE Format USB Device button to format the connected USB device.

Please, enter your PIN code to access this menu and press OK to start formatting.

Press  to leave this menu.

NOTE: After performing the Safely Remove function, the USB device is no longer

accessible by your receiver. To gain access to you're the storage device

again, re-insert it or switch the receiver to standby and on again.

WARNING: Formatting will permanently delete ALL data stored on the connected

device. Always make backups of data on your USB storage device before

using it with this receiver.

STRONG will not take responsibility for any loss of information or

circumstances caused by loss of information.

NOTE: It is possible to use USB storage devices already formatted in NTFS.

1.32 Network

This menu consists of the following submenus: RSS, Weather, EVOTV portal and IP Settings. First connect a

CAT5E (or higher quality) cable to the RJ-45 (ETHERNET) port of your receiver and ensure the other end is

connected to the internet accordingly. If there are questions or problems with the internet connection,

we recommend you to check details via the support or helpline of your internet provider.

Before you start to use the Internet functions please check the setup of the Internet connection via IP

Settings menu and conrm SET with OK. Usually the Internet connection should now been established

without any problem and ready to use. A message will inform you if the connection has been setup

successfully or not, use OK to conrm and press 9 to leave this menu.

Inside the menu use pq to highlight the submenu of choice and press OK to enter. Press  to quit or

9 to go one step back.

1.32.1 EVOTV portal

Accessing this menu will load the EVOTV portal. Follow future instructions on screen to get access to

content.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Strong SRT 8550 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info