Bedienungsanleitung Strong SRT 8910 (Seite 6 von 19) (Englisch)

480557

Zoom out

Zoom in

Vorherige Seite

1/19

Nächste Seite

PART 2 • English

English

22. Heat - The product should be situated away from heat sources such as radiators, heat

registers, stoves, or other products (including ampliﬁers) that products heat.

Safety Warnings

1. The normal operating temperature of the digital receiver is between 0° C and 40° C

2. Please prevent the receiver from operating in dusty conditions.

3. The receiver shall be operated in ventilated environment away from heat sources. No

objects ﬁlled with liquids, such as vases, shall be placed on the unit. The receiver shall not

be exposed to dripping or splashing. Should this happen, disconnect your receiver from the

main and consult your dealer.

4. Do not open or disassemble the outer chassis in order to avoid the danger of electric shock

and damaging to the receiver. Opening the chassis will also void the warranty.

5. The antenna connected to the receiver shall be equipped with anti-shock device from

lightning. Where the mains plug or an appliance coupler is used as the disconnected device,

the disconnected device shall remain readily operable.

6. If the receiver is inoperative, please consult the Customer Support.

This receiver has been manufactured to satisfy international safety standards. Please read the following

recommended safety precautions carefully.

MAINS SUPPLY: AC 90 ~ 240 V ~ 50/60 Hz

OVERLOADING: Do not overload wall outlets, extension cords or adapters as this can result in ﬁre or

electrical shock.

LIQUIDS: Keep liquids away from the receiver.

CLEANING: Before cleaning, disconnect the receiver from the wall socket. Use a cloth lightly

dampened with water (no solvents) to clean the exterior.

VENTILATION: Do not block the receiver ventilation holes. Ensure that free airﬂow is maintained

around the receiver. Never store the receiver where it is exposed to direct sunlight or

near heating equipment e.g. a radiator. Never stack other electronic equipment on top

of the receiver. Place the receiver at least 30 mm from the wall.

ATTACHMENTS: Do not use any attachment that is not recommended by the manufacturer; it may cause

a hazard or damage the equipment.

CONNECTION: Connect all components before plugging any power cords into the wall outlet. Always turn off

the receiver, TV and other components before you connect or disconnect any cables.

SERVICING: Do not attempt to service this product yourself. Any attempt to do so will make the

warranty invalid. Refer all servicing to a qualiﬁed service agent.

LIGHTNING: If the receiver is installed in an area subject to intense lightning activity, protection

devices for the receiver mains connector and modem telephone line are essential. The

individual manufacturer’s instruction for safeguarding other equipment, such as TV set,

Hi-Fi, etc., connected to the receiver must also be followed during lightning storms.

GROUNDING: cables must be grounded. The grounding system must comply with SABS 061.

NOTE: Dispose the used batteries at designated place for environment protection

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Strong SRT 8910 Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info