Bedienungsanleitung Strong SRT55UC4013 (Seite 21 von 23) (Englisch)

751449

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

6.2.5 Software update via USB

From time to time you can check if there is an improved software version available. This can be viewed

and downloaded from our website www.strong.tv. Search the model number on our website's service

support section. If there is an improved software version you can download the  le and copy it to the

root of a USB device. Then press  button to select Software Update (USB) from the SETUP menu

on your TV. Afterwards plug your USB device into the USB slot and press OK to update the respective

software. Con rm with Yes using  . When the update is completed, remove the USB stick, disconnect

your device from the main power supply and plug in again.

7.0 TROUBLESHOOTING

Before calling a service technician, review following information for possible causes and solutions for the

problem you are experiencing. If the TV does not work properly after checking it, please contact your

local service line or STRONG dealer. Alternatively, you can send a support mail via our website www.

strong.tv.

Problem Possible cause and solution

No picture,no sound 1. Check if the fuse or circuit breaker is working.

2. Plug another electrical device into the outlet to make sure it is

working or turned on.

3. The power plug is in bad contact with the outlet

4. Check the signal source.

No colour 1. Change the colour system.

2. Adjust the saturation.

3. Try another channel. Black-white programme may be received.

The remote control does

not work

1. Change the batteries.

2. The batteries are not installed correctly.

3. Main power is not connected.

No picture, normal sound 4. Adjust the brightness and contrast.

5. Broadcasting failure may happen.

Normal picture, no sound 1. Press the volume up button to increase the volume.

2. The volume is set to mute, press ! to restore the sound.

3. Change the sound system.

4. Broadcasting failure may happen.

Unorderly ripples on the

picture

It is usually caused by local interference, such as cars, daylight lamps and

hair driers. Adjust the antenna to minimize the interference.

Snowy dots, blocking and

interference

If the antenna is located in the fringe area of a television signal where

the signal is weak, the picture may be marred by dots, show blocking

or break-ups. When the signal is extremely weak, it may be necessary to

install a special antenna to improve the reception.

1. Adjust the position and orientation of the indoor/outdoor

antenna.

2. Check the connection of the antenna.

3. Fine tune the channel.

4. Try another channel. Broadcasting failure may happen.

Radio frequency

interference

This interference produces moving ripples or diagonal streaks, and in

some case, loss of contrast in the picture. Find out and remove the radio

interference source.

English

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Strong SRT55UC4013 Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Strong SRT55UC4013

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info