Bedienungsanleitung Stylies Titan (Seite 20 von 106) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch)

785935

Zoom out

Zoom in

Vorherige Seite

1/106

Nächste Seite

FIRST USE / OPERATION

Please note: never transport the device with a full water tank.

Possible hazards:

too much water from water tank comes into the Main Base (17), this overloaded water level

will cause dramatic reduction of mist output of the device.

water can easily come out from the Main Base (17).

the water tank can fall off from the Main Base (17) and get damaged due to the heavy weight

from the water (and water can leak on to the floor).

1. For this reason, Main Base (17) of the Stylies TITAN humidifier should be placed first with

empty Water Tank (16) in a suitable location.

2. When the device is in the desired location: Fill Water Tank (16) with fresh water and

screw the Tank Cover (19) back on firmly and check that it is sealed properly. Place Water

Tank on base.

3. Plug Power Cable into the power socket. Switch on the device by pressing the On/Off switch

on the Control Panel (3), the display lights up white.

Caution: If the red «Low water» warning lights up, the humidifier cannot be switched on.

Check if the water tank is full. If so, it may take several minutes to refill the water collector

(24) if necessary (the red light then goes out).

4. The Mist outlet (1) can be turned 360°. Never point the outlet at walls or furniture, etc. Don’t

point the mist outlet toward the cable, otherwise the hygrostat can’t measure the relative room

air humidity properly. The Display panel (7) shows the current relative air humidity in the

room, e.g. «36 % RH».

5. Select the desired air humidity level by pressing the humidity button on the Control Panel

and adjusting with the and buttons. Settings are in 5% stages from 40 % to 75 % rel. air

humidity. «Co» means continuous operation without automatic control. We recommend

40-60 % rel. air humidity for living areas.

When the display (7) stops flashing, the setting has been saved and the current air humidity is

displayed again. The humidifier starts automatically as soon as the humidity is lower than the

setting, and stops when it is higher. During humidification the lamp on the left of the humidity

display lights up.

Note: If «Co» (continuous operation) is set, the humidifier WILL NOT STOP OR START automati-

cally. To avoid excessive humidity, use «Co» for a short time only.

6. Set the mist quantity in three stages by pressing and (1 = low, 3 = high).

7. The display lights up as soon as any button is pressed, and goes dark 15 seconds after-

wards. The air humidity is displayed even when switched off (to prevent this, pull out the pow-

er plug).

8. Press the timer key to activate the automatic shutdown time (display flashes «1H»). Ad-

just the shutdown time in hours with the and keys (1-12 hours or «–-- H» for no timer).

9. «Low water» warning: this red LED , lights up if the water collector is empty or too low. In this

case turn off the «On/Off» power switch and fill the tank with fresh water. Then replace the

tank in the base and turn the power on again.

Note: When you remove the tank, some water can flow out of the descaler cartridge.

To prevent damage, always turn off the power when the «Low water» warning lights up.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Stylies Titan Seite 20

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info