Bedienungsanleitung Sunbeam EM6910 (Seite 34 von 44) (Englisch)

654315

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Descaling

Scale is a surface build up of minerals that

naturally occur over time in all appliances

that are involved with the heating of water.

Therefore the espresso machine will require

occasional descaling. It is recommended

that the espresso machine is descaled every

4-6 months, this will vary depending on the

frequency of use and water hardness.

Descaling solution

Use any of the following when descaling the

espresso machine:

 Sunbeam Espresso Machine Descaling

Tablets (EM0010)

 Sunbeam Liquid Descaler (KE0100), or

 Vinegar Solution.

Descaling the espresso machine

Note: Ensure the espresso machine is turned

off and the power cord is unplugged.

1. Remove the water reservoir and rinse clean.

Depending on the descaling solution being

used use one of the following:

A. Sunbeam Espresso Machine Descaling

Tablets

Fill the water reservoir with 1 litre of warm

water and place a descaling tablet into the

reservoir. Once the tablet has dissolved

replace the reservoir, this takes about 5-7

minutes.

B. Sunbeam Liquid Descaler

Fill the water reservoir with approximately

1.5 litres of water, add 1 capful of

Sunbeam Liquid Descaler and replace the

reservoir.

C. Vinegar solution

Fill the water reservoir with approximately

1.5 litres of warm water, add 3 tablespoons

of vinegar and replace the reservoir.

2. Should the group handle be attached to

the group head remove it, rinse thoroughly

under running water and set aside.

3. Using a screwdriver unscrew the brewing

filter/shower screen from the underside of

the group head.

4. Remove and set aside the filter/screen and

screw in a safe place.

Important: Be careful not to lose the

filter/screen and screw once you have

disassembled the group head.

5. Place a sufficiently large container under

the group head.

6. Insert the power cord into a 230-240V AC

power outlet and switch the power ‘ON’.

Press the ‘POWER’ button once to turn the

espresso machine on.

Note: Remember if the ‘POWER’ light

is flashing green this indicates that the

espresso machine is on and is heating up.

When the green light above the ‘POWER’

button stops flashing and turns to a constant

red light this indicates that the espresso

machine is heated and ready to use.

Additionally the lights above the ‘MANUAL’,

single

and double espresso buttons

will show a constant green light.

7. Press the ‘MANUAL’ button and allow

half the solution to cycle through the

group head and then once again press the

‘MANUAL’ button to stop the flow.

Important: Do not run descaling solution

through the steam wand.

Note: As a safety mechanism the espresso

machine is programmed to automatically stop

the water flow after 240mls, therefore you

will need to press the ‘MANUAL’ button again

to restart the water flow.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sunbeam EM6910 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info