6
GAS REQUIREMENTS
• Use propane, butane or their mixtures gas only.
• The pressure regulator and hose assembly to be used must conform to local standard codes.
• The installaon must conform to local codes, or in the absence of local codes, with the standard for the storage and han-
dling of liquid petroleum gases.
• A dented, rusted or damaged tank may be hazardous and should be checked by your tank supplier. Never use a tank with a
damaged valve connecon.
• The tank must be arranged to provide for vapor withdrawal from the operang cylinder.
• Never connect an unregulated tank to the heater.
LEAKAGE TEST
• Gas connecons on the heater are leak tested at the factory prior to shipment. A complete gas ghtness check must be
performed at the installaon site due to possible mishandling in shipment or excessive pressure being applied to the heat-
er.
• Make a soap soluon of one part liquid detergent and one part water. The soap soluon can be applied with a spray bole,
brush or rag. Soap bubbles will appear in case of a leak.
• The heater must be checked with a full cylinder.
• Make sure the safety control valve is in the OFF posion.
• Turn the gas supply ON.
• In case of a leak, turn o the gas supply. Tighten any leaking ngs, then turn the gas supply on and re- check.
• Never leak test while smoking.
CAUTION
PLEASE READ CAREFULLY THE FOLLOWING SAFETY GUIDELINES BEFORE OPERATION
EN
WARNING
Do not aempt any changes to the device in any way to apply. Incorrect installaon, improper use,
