514908
13
Zoom out
Zoom in
Vorherige Seite
1/220
Nächste Seite
13
ENGLISH
Adjusting the footrest
CAUTION!
Do not stand on the footboard!
Even if the user is
sitting in the chair, there is still a
risk of tipping over and injury.
CAUTION:
When transferring, do not stand
on the footboard, there is a risk
of tipping over and injury.

you to adjust the footrest to
correspond to the length of your
lower leg and re-attach the footrest.
The angle of the footrest may be
individually adjusted by loosening

on the footrest prevents the feet
slipping off accidentally. Make sure
that after any adjustment work, all


Footplate Adjustment
Adjusting the seat height
To adjust the rear seat height
release





reduce the length of the axle stem
as required.

NOTE:
An adjustment to the castor angle may be necessary when
adjusting the rear seat height .
Seat
High-mount footrest
The high-mount footrest is fitted on
the inner part of the frame
and permits a higher footrest position

Fig. 5.14
1
2
3
Seat sling
To tighten the upholstery, please use the straps below the
upholstery.
Link Rear Suspension
WARNING!
Rear suspension can affect the
stability of the wheelchair. To avoid a

when becoming familiar with new
equipment.
1. Tuning the 4-Link Rear
Suspension
a. To stiffen the suspension, turn the



b. To soften the suspension, turn the


suspension system from underneath

2. Alignment of Suspension Link
Arms

are set at the factory to ensure proper tracking
and performance of the 4-Link Rear Suspension system.
Setting the Toe to Zero



until the ball is centered in the level. The toe is now set at zero


tube is centered left-to-right relative to the wheelchair frame, and
the flat portions underneath outer camber tube clamp are
parallel side to side. The end of the camber tube should be flush
with the outer most portion of the camber tube clamp. Torque

Setting the Toe to Zero–
Alternative Method
Place the entire wheelchair on a flat
horizontal table or ground surface.

side, unless equipped with anti-tips

camber tube clamp. Locate the flat
surfaces on the front and rear of the

that is known to have an accurate


on the flat horizontal surface and up
against the flat of the camber plug.
Rotate the camber tube and plug
assembly until the flat surface of the
camber plug is parallel to the



tube is centered left-to-right relative to the wheelchair frame and
the flat portions underneath outer camber tube clamp are
parallel side to side. The end of the camber tube should be flush
with the outer most portion of the camber tube clamp. Torque the

NOTE– When turning the 4-Link Rear Suspension, always make
one change at time and write down the
change. This takes patience, but allows you to understand how
each change affects the ride of the
wheelchair in conjunction with rear suspension.
NOTE– Lower shock mount is designed to have a loose feel,
this is by design to allow for proper suspension travel.
NOTE
clamp to the shock camber clamp.
3. Maintenance
The maintenance requirements listed below should be followed
along with general wheelchair
maintenance called out in Section XI.
a. Do not apply lubrication to shock end bushings or coils.
b. You can apply lubrication to the link ends after cleaning with a
mild soap and soft
brush.
c. Use a soft brush to clear any dirt or debris from coil system.
d. Never use a high-powered washer for cleaning the 4-Link
Rear Suspension.
1
Fig. 5.11
Fig. 5.13
2
3
Fig. 5.12
Options - Snoll on
Please see extra manuall for Snoll on
Fig. 5.7
BALL
C
B
Fig. 5.9
PARALLEL
D
C
Fig. 5.10
H
I
G
E
F
Fig. 5.8
D
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sunrise Medical Helium 2013 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info