767543
10
Zoom out
Zoom in
Vorherige Seite
1/36
Nächste Seite
Components
Lid
5 Trays
2 Inlay mats
Base
Control panel with LED display
Operation
Operating voltage: 220-240V~, 50/60Hz, 200-240W
Before first usage:
o Please remove all packaging materials and clean all trays and inlay mats in accordance with
the section "Cleaning". Place the inlay mats on the trays and stack the trays on top of each
other as shown in the section "Components". Please connect the appliance to the power supply.
o When the appliance is used for the first time, it must be put into operation for 30 minutes without
any content. Possible smoke or odour development due to production-related residues are
normal during this time. Please ensure adequate ventilation. When the time is over, the trays
and inlay mats must be cleaned again. To do so, please remove the appliance from the power
supply (see section "Cleaning").
Preparation:
o Please prepare the food to be dried. Fruit, vegetables, herbs, nuts, bread, meat or fish are
suitable for the drying process. For vegetables and fruit it is recommended to cut them into thin
slices.
o Spread your prepared food on the trays while starting with the lowest one. Make sure that there
is space between two slices of food. Do not overfill the trays. Please always use at least three
trays to ensure the functionality of the appliance.
o The fine-meshed inlay mats can be used for particularly fine or small foods. If required, the
height of the trays can be adjusted as well. For bigger food, arrange the trays in a way that the
clips of two trays are positioned directly on top of each other, as shown in the following picture:
o As soon as you have finished the preparation, close the uppermost tray with the lid.
Drying process:
o Control panel:
5
Timer setting Temperature setting
On/Off
o Please connect the appliance to the power supply. An acoustic signal sounds.
o Switch the appliance on by using the on/off button. Every operation on the control panel is
accompanied acoustically. The display shows the default setting "10.00" which indicates a
drying time of 10 hours. As soon as the dot between the hours and minutes flashes, the drying
process begins. Due to the built-in fan, warm air is circulated evenly over all floors, drying your
food.
o Use the timer setting button on the control panel to adjust the drying time between "00.30"
10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Suntec FDH-8595 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info