• Never use the appliance with wet hands, in the
shower, in bathtubs or near containers filled with
water or other liquids.
• Please do not use the appliance while standing, use
it while sitting.
• Never use the appliance without water.
• Please do not place the appliance in the bathtub or
shower cabin when filling in water.
Components
1. Housing 5. Massage rollers
2. Control knob 6. Infrared lamps
3. Bubble bar 7. Container for bath additives
4. Splash guard/Handle
Operation
• Operating voltage: 230V~, 50Hz, 450W
• Please remove all packaging materials first.
• Please fill the pool with water and make sure that you do not exceed or fall below the min. and max.
water quantity. You will find the corresponding markings on the inside right-hand side of the pool. If you
wish, you can also use warm water.
• Please connect the device to the power supply. Smoke or odour can develop during initial start-up.
These are due to production-related residues and are normal. Please ensure adequate ventilation.
• You can choose between the following settings on the control knob as you wish:
0. „Off“ – Turning off the appliance
1. „Vibration/Bubble” – Vibration and bubbles
2. „Heat/Infrared” – Water heating and infrared
3. „Heat/Infrared/Vibration/Bubble” – Water heating, infrared, vibration and bubbles
• With the help of the container for solid bath additives, you can add rose petals or ginger slices to your
footbath, for example. Please do not use foaming bath additives.
• To protect the motor and thus ensure its longevity, it is recommended to use settings 1 and 3
continuously for a maximum of 10 minutes each. Please then switch off the unit or change to setting 2
to cool down the motor. After 5 minutes all settings can be used again.
• Please switch off the unit and remove the power cable from the power supply. Please empty the basin
and make sure that the water does not drain off against the control knob.
