Bedienungsanleitung SureFlap Microchip Cat Flap - serie nr 2000000 plus (Seite 5 von 146) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch)

782757

Zoom out

Zoom in

Vorherige Seite

1/146

Nächste Seite

Place some dry food or a treat inside the tunnel as close to

the clear plastic door as possible. The aim is to encourage

your pet to put its head inside the tunnel.

Tip: You could also try using catnip.

Batteries

Always use 4 good quality AA 1.5V alkaline batteries to ensure the best performance of

your cat flap. For example the Energizer or Duracell brands. When the batteries start to run

low, the indicator light will flash red once every 5 seconds.

To insert the batteries remove

the battery compartment

cover from the front of the

cat flap.

Remove the battery compartment cover to reveal the 'Add a Pet'

button and press it for 1 second to enter the Add a Pet mode.

When your cat enters the tunnel to eat the food, the sensors

activate and the cat flap saves the microchip ID. Please see

page 23 - Help and support, for tips to encourage your cat to

use the cat flap.

Make sure the manual lock is set to

Position 1 before you begin. See

page 21 for more information on

the manual lock.

Insert the batteries into the compartment as shown,

with the + and - in the correct orientation. Then

replace the compartment cover.

Programming your cat flap

To start using your cat flap, you need to program your cat's microchip ID into the cat flap.

This process is only required once for each cat, as their ID will be stored in the cat flap's

memory. Follow the simple step-by-step guide to carry out this process. We strongly

advise doing this prior to fitting, however it is possible to program once already fitted

following the same steps detailed below.

The catch will now open, allowing your cat to pass through

the flap and the indicator light will flash once every second.

The cat flap is now in Add a Pet mode.

If your cat does not have a microchip, you can buy a Sure Petcare RFID Collar Tag from

surepetcare.com/accessories. To add the tag to the cat flap, repeat steps 2,3 and 5 by

holding the collar tag inside the tunnel, make sure you push the tag against the flap. Do

not wear metal jewellery during this process as it can interfere with the cat flap's sensors.

Once your cat’s microchip ID has been successfully added,

the flap reverts to standard operation. The indicator light will

stop flashing and the catch will lock (move up) when the cat

has moved away from the cat flap.

Step-by-step

Manual lock - Position 1

- Cancel programming your cat's microchip ID into the cat flap

(press the button again for 1 second, aer starting Add a Pet mode)

- Wipe the cat flap's memory (hold down for 10 seconds. The catch

will drop down and come back up once complete)

The 'Add a Pet' button has some extra features

Step-by-step continued

+ -+ -

The cat flap can store up to 32 cat IDs so if you want to add

more than one just repeat the steps above for each cat. If

your cat flap is already installed, but you want to add an

additional cat then repeat steps 2-6.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

SureFlap Microchip Cat Flap - serie nr 2000000 plus Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info