•
MAINTENANCE
The instrument should be soaked, thoroughly rinsed with fresh water, then dried
with a soft towel after each dive. Make sure that all salt crystals and sand particles
have been flushed out. Check the display and the transparent battery compartment
cover for possible moisture or water. DO NOT use the dive computer if you detect
any moisture or water inside. In order to limit corrosion damage, remove the battery
and moisture from the battery compartment. Contact an authorized Suunto dealer
for battery replacement or other service.
CAUTION!
• Do not use compressed air to blow water off the unit.
• Do not use solvents or other cleaning fluids that might cause damage.
• Do not test or use the dive computer in pressurized air.
•
WATER RESISTANCE INSPECTION
The water resistance of the unit must be checked after replacing the battery or
after other service operations. The check requires special equipment and training.
You must frequently check the transparent battery compartment cover and the
display for any sign of leaks. If you find moisture inside your dive computer, there
is a leak. A leak must be corrected without delay as moisture will seriously damage
the unit, even beyond repair. SUUNTO does not take any responsibility for damage
caused by moisture in the dive computer unless the instructions of this manual are
carefully followed. In the event of a leak, immediately take the dive computer to
an authorized SUUNTO dealer or distributor.
FAQs
For more information on service, please refer to FAQs on www.suunto.com.
90
