3. DIVING WITH THE SOLUTION
á
This section contains instructions on how to operate the SOLUTION
á
and interpret
its displays. Each display has been carefully designed to provide important
information you will need to plan your dive or dive series.
You will find that the SOLUTION
á
is easy to use and read. Each display shows
only the data relevant to that specific diving situation. For example, while you are on
a dive, surface interval data is irrelevant and therefore not shown. On the other
hand, while you are on the surface after a dive, remaining no-decompression time
for that dive is irrelevant and therefore replaced with information for your next dive.
3.1 USE OF WATER CONTACTS
As described in Section 2.1, "Water Contacts", the SOLUTION
á
is controlled with
the COM (common), ON/PLAN, and TIME/MODE contacts, as follows:
Activation: touch the ON/PLAN and COM contacts.
Dive planning: once the SOLUTION
á
has been activated, touch the ON/PLAN and
COM contacts.
Clock: touch the TIME/MODE and COM contacts for a second. The time is
then displayed for four seconds.
When the TIME/MODE and COM contacts are being touched over two seconds, the
display will start to scroll through the following modes. Lift your fingers when the
desired mode is displayed:
Memories: at LOG the logbook and profile memories
are accessed.
Dive history: at HIS the history memory is accessed.
Altitude/ personal adjustment setting: at Alt the altitude and/or personal
adjustment can be set.
Dive simulator: at dSI the dive simulator is ready for use.
Time setting: at Set the clock can be adjusted.
