780w 2 STROKE GENERATOR SML34GEN
OPERATION INSTRUCTIONS
Warning: Before using your generator be sure to
read the instruction manual carefully.
1. ASSEMBLY
Fit the carrying handle to the top of the petrol tank and
secure in position using the 2 screws provided (See fig
2).
2. LOCATION & GROUNDING
Before using this generator it must be prepared
correctly before use. Locate the generator on firm level
ground away from buildings or other structures
ensuring that the exhaust is not obstructed.
Warning: It is advisable to properly earth-ground your
generator before starting using a wire and a small earth
stake.
Note: The wire and earth stake are not supplied with
the unit.
Earth Spike and Cable can be purchased at your local
camping supplies, or alternatively an Earth spike can be
made, and it is suggested you get advice from a
registered electrical trades person.To make a Spike use
a Copper tube or Copper Rod 12mm diameter, a
minimum length of 200mm and with an M6 Machine
screw one end.The cable used should be a Maximum
length of 1 metre and a Minimum of 1.0mm2 to carry a
10amp load.The cable should be attached to the
Generator at the Earth point (See fig 3) and to the
Spike between a flat washer and the Copper with a lock
washer under the head of the M6 Machine screw in a
similar fashion to the Earth point screw on the
generator.
When placing the Spike into the ground the Generator
must not be running and it is suggested that the Spike is
pushed into the ground by at least 100mm so that it is
firm and a litre of water poured around it to ensure
good Earth continuity.
Fig 3
Fig 2
