Bedienungsanleitung Switel BCC59 (Seite 36 von 44) (Deutsch, Englisch, Französisch, Italienisch)

687773

Zoom out

Zoom in

Vorherige Seite

1/44

Nächste Seite

Operation

4 Operation

Once you have set up your baby monitor, you will be able to hear the sounds in your baby´s room

through the parent unit. You will also be able to see those sounds as the green sound sensor lights

around the top of the parent unit, which rise and fall with the volume level.

a Note: If the connection between the parent unit and baby unit is broken at any time the green

“Link“ light on the parent unit will flash and the green sensor light will cease to react to any

sounds. To re−establish the “Link“, follow the directions in the “Troubleshooting“ chapter.

Powering on/off the baby monitor

After having connected the baby monitor you will have to switch on both units. Press the On/Off key

on each unit. To switch off the unit press and hold down the On/Off key.

Volume

You can adjust the volume at which you hear your baby by using the keys ▲ and ▼ on the parent

unit. This will not effect the sensitivity of your baby monitor, only the volume at which you hear those

sounds through the parent unit.

Battery charge indicator and battery low warning

The parent unit will work up to 10 hours out of the charger pod, but this depends on the level of

charge in the batteries. The charge level is indicated by the battery icon on the Display. If the charge

becomes low, a “battery low warning beep“ will sound and the battery icon on the parent unit´s

Display will begin to flash. If this occurs you should return the parent unit to the charger pod to

re−charge the batteries. You can still use your parent unit from the charger pod.

On the display you can see the charging status:

Battery icon filled = full capacity

Battery icon 2/3 filled = approx.half capacity

Battery icon 1/3 filled = batteries nearly exhausted

Battery icon not filled / frame flashes = batteries must be charged

Sound alert

You can set your parent unit to give an extra warning “beep“ should the noise levels in your baby’s

room activate the light on the sound sensor. This is particularly useful if the volume of your parent

unit is turned down and you are just using the sensor light to monitor the noise levels in your baby’s

room.

Parent to parent paging

Useful if one parent is in the baby’s room and needs to contact the other. Also helps to find a mislaid

parent unit.

At the baby unit

Press and hold the Page Key for 2 seconds. The parent unit will emit a tone. The tone can be swit-

ched off by pressing any key on the parent unit or by pressing the page key on the baby unit once

again.

Night light

The baby unit has a night light which emits a soft starry glow, providing comfort and re−assurance

for your baby and allowing you to see them in a darkened room. You may also turn the night light on

and off from the parent unit.

BCC 59 eco zero_GB_206x145mm_spar_DTP direkt KG 03.03.11 16:28 Seite 34

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Switel BCC59 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info