673285
23
Zoom out
Zoom in
Vorherige Seite
1/31
Nächste Seite
22
10. Inspection and maintenance before riding
CHECKING THE FRONT AND REAR LIGHTS
Start engine and turn on the head lamp switch. Check if head lamp and rear lamp come on.
Check the brightness and direction of front light by wall to see if it is correct.
Check the head lamp cover if it is dirty, crack, or loosen.
CHECKING THE BRAKE LIGHT
Turn the ignition switch key to "
" position, hold the hand-braking levers for front and rear wheels.
Check if the brake lights come on.
Check the brake light cover if it is dirty, crack, or loosen.
CAUTION:
Use only specified specification bulbs, do not use bulbs with different specifications to avoid
damaging electrical system, burning out bulbs, and discharging the battery.
Do not modify or add other electrical components to prevent over load or short circuit which may
result in a fire and burn down the scooter in serious cases.
CHECKING FOR FUEL LEAKAGE
Check fuel tank, fuel cup, fuel hoses, carburetor for leakage.
CHECING THE LUBRICATION OF BODY’S VARIOUS MECHANISMS
Check the body’s pivot points if they have enough lubrication.
(For example, the pivot points on the main stand, the side stand, and the brake lever…etc.)
CHECKING THE SPARK PLUG
Remove the cap of spark plug cable (remove the spark plug using the spark plug wrench in the tool kit).
Check the electrode if it is dirty or fouled by carbon deposits.
Remove the carbon deposits on the electrode with steel wire, and clean the spark plug with gasoline,
then, wipe dry with a rag.
Check the electrode, and adjust its gap with a feeler gauge. (should be gapped to 0.7~0.8 mm)
Hand tight the spark plug as far as it can go and then tighten it another 1/2~3/4 turns with a wrench.
WARNING:
The engine is very hot after running. Pay attention not to get burned.
Use only spark plugs suitable for the engine specifications of this scooter recommended by the
manufacturer. (Refer to specifications.)
Spark Gap
Spark plug cap
23

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

sym-cruisym---lv30-25w

Suche zurücksetzen

  • Ich hätte gerne eine Bedienungsanleitung für sym cruisym-LV30-25W in Deutsch .Kann mir da jemand Helfen Eingereicht am 15-3-2020 10:26

    Antworten Frage melden
  • gibt es für die cruisym 300 i abs eine deutsche betriebsanleitung Eingereicht am 31-1-2019 20:04

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Sym CRUISYM - LV30-25W wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info