5
GB
Assembling Grand Excel
1 ASSEMBLING GRAND EXCEL
The Grand Excel ergotrainer consists of the collapsible CycleForce frame on which you mount
your bike and the Grand Excel computer. The CycleForce is suitable for racing and hybrid bikes
and mountain bikes with a wheel diameter of 610 - 720 mm.
Assembling the Trainer
The following steps show how to assemble and adjust the trainer.
1 Press nut A into cap B and slide the cap into the frame tube (fig.1).
2 Assemble base C to the frame using bolt D. Tighten bolt D but make sure
the base is still adjustable.
3 Unfold the trainer and place it on a level surface. By fully squeezing grip E,
the trainer can be folded out or collapsed (fig.1).
4 Turn base C to the correct position (fig.2). Tighten bolt D firmly and attach
anti-slip rubber F (fig.3).
5 Assemble 2 rubber rings G and part K to handle H (fig.4). Than assemble the complete handle
to the frame, shove unit I into part K of the handle and turn bolt J until the mag unit is firmly
tightened but it should still be able to move (fig.3).
6 Replace the quick-release skewer on the rear wheel with the skewer supplied by Tacx. This
assures ideal clamp fitting and stability. Place the bike in the trainer and adjust the wing bolt L
of the trainer, so that the speed tension clamp M will close without forcing. Forcing could cause
damage!
7 Fix wing bolt L by tightening wing nut N.
