Bedienungsanleitung Tanita BC-1000plus (Seite 9 von 17) (Englisch, Spanisch)

545063

Zoom out

Zoom in

Vorherige Seite

1/17

Nächste Seite

Troubleshooting

• Do not step onto the platform before the platform beeps once and the Green Indicator Light blinks.

• Do not step off until hearing a double beep or the Green Light remains solid (stops blinking), the measurement is taken, and the

readings are displayed on the applicable device (e.g. Garmin Watch, Tanita Remote Display, and/or PC).

• If you do not step onto the platform within 30 seconds after Green Indicator Light begins blinking, the power will shut-off

automatically.

• Interference may occur if multiple platforms are present. Please use only one platform in any given area.

• Constant Red Indicator Light

Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned on the measuring platform.

(see p.2)

Make sure to step onto the platform only after it has beeped twice or the Green Indicator Light is blinking.

The unit cannot accurately measure your weight if it detects movement. Please stand on the platform keeping movement to a

minimum.

If Body Fat Percentage is more than 75%, readings cannot be obtained from the unit.

Reading cannot be obtained if the weight capacity is exceeded. Weight capacity is 440lb (200kg).

• Blinking Red Indicator Light

Batteries are low. When the Red Indicator Light is blinking, replace the batteries immediately, since weak batteries will affect the

accuracy of your measurements. Change all the batteries at the same time with new batteries.

Specifications

BC-1000 plus

Weight Capacity

440lb / 200kg

Weight Increments

0.2lb / 0.1kg

Power Supply

DC 6V (LR6 - AA Battery x 4 included)

Power Consumption

100 mA maximum

Temperature Range of usage

41°F - 95°F / 5°C - 35°C

Federal Communications Commission and Canadian

ICES Notice

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

•Reorient or relocate the receiving antenna.

•ncrease the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

•Consult the dealer or an experienced radio or television technician for help.

FCC WARNING

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate

the equipment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tanita BC-1000plus Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info