803889
11
Zoom out
Zoom in
Vorherige Seite
1/12
Nächste Seite
TROUBLESHOOTING GUIDE
1. If the information listed in the troubleshooting guide can’t solve your problem, please
email us for help.
2. Failure to keep this unit clean from mineral deposits may affect operation of this unit.
3. Customer failure to follow these instructions may void the warranty.
1
3
21. Spring
2. Water Floater
3. Sealing Ring
Problem Possible Cause Solution
Power adapter not plugged in
No power from power outlet
Power adapter not connect
to the input port
Ensure the power adapter is
properly plugged in
Try another power outlet
Connect power adapter to
the input port.
LED indicator is off
Ensure the oater is
secured properly to the tank
bottom allowing water to pass
through to the base
2
Adjust the water oater to
a horizontal position and
make sure it can rise up with
water
2
Water oater stuck
2
No water in the water
reservoir
LED indicator stays red
Not enough water inside the
tank Rell and reinstall the water tank
The LED Indicator will light up,
but no mist or little mist is
produced
Mist level is set too low Adjust to maximum mist
Mineral buildup on the
atomize
Feel if any air comes out from
the nozzle. If yes, then clean
water scale on the atomizer
with s soft cloth as instructed
The base might be overlled
Remove the tank, empty the
base and place the lled tank
on the empty base
Tank leakage
Tank may be damaged Check for possible cracks in
the tank, replace if necessary
Tank cap is not tightened
securely Tighten the tank cap
Spring stuck
Ensure the spring is
properly secured to the tank
bottom allowing water to
pass through to the base.
1
1
Sealing ring was not
installed on tank cap
Install the sealing ring on
the tank cap, please contact
us if it is missing
33
Mist level is set too high for
the room size
1. Check if the room is too
humid and adjust to lower
mist. 40%-60% works best
2. Open door and windows,
or change to a larger room
Air inlet is blocked
Humidier should be placed
on a hard at surface, 2 feet
above the oor, 12 inches
away from the wall. Point
nozzle away from wall or
window
Low indoor temperature
leads to liquefaction
Raise the room temperature
to 25°C / 77°F
Mist height is low, damping
surrounding desk or oor.
Condensation forms around
humidier or on windows
and walls
16
15
11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für TaoTronics TT-AH038 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info