Bedienungsanleitung Tascam CD-200i (Seite 31 von 36) (Englisch)

587251

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

TASCAM CD-200i

By connecting an iPod with the iPod dock on the front

panel, this unit can control the iPod and output its sound/

video. Moreover, it can also recharge the iPod when this

unit’s power is ON.

iPod dock

Connect an iPod following the instructions on page 16.

Always attach a dock adapter suitable for your iPod to

the connector. Dock adapters are not included with this

product. Use the dock adapter included with your iPod or a

commercially available Apple iPod Universal Dock Adapter

made by Apple Inc.

Read the instructions on page 16 carefully and proceed

•

with caution in order to avoid damage to the connectors

and sudden bursts of noise when connecting and discon-

necting an iPod.

See our website (http: //www.tascam.com/) for informa-

•

tion about compatible devices.

Controlling an iPod

The following keys on the CD-200i front panel and remote

control (RC-CD200i) can be used to control the iPod.

PL AY/READY key (¥/π): Play/Pause

STOP key (

): Pause

SKIP keys (



): Previous and Next

(press and hold for Rewind and Fast-forward)

FOLDER keys (

˙/¥

): Skip through albums

REPE AT key: Cycle through repeat single track, repeat all

tracks and repeat off modes

PLAY MODE key: Cycle through continuous, song shuffle

and album shuffle playback modes

DISPL AY key: Sets whether the iPod video is shown on the

iPod itself or output from this unit’s VIDEO OUT jack

CAUTION

Depending on the iPod software version, operation

from the CD-200i might not work.

Settings made on the iPod

Make the following settings on the iPod in order to output

video. These settings cannot be made from the CD-200i.

TV Signal setting (NTSC or PAL)

•

TV Screen (or Widescreen) setting

•

iPod playback

1. Press the PLAY MODE/INTRO CHECK (SOURCE

SEL) while pressing and holding DISPLAY (SHIFT)

key at the same time, or press the SOURCE SEL on

the remote control, and set the output sound source

to iPod.

PLAY MODE/INTRO CHECK

(SOURCE SEL) key

SOURCE SEL key

Doing this makes it possible to control the iPod from the

CD-200i front panel and remote control (RC-CD200), as

well as to output the iPod’s sound and video signals.

Setting the iPod video output

When iPod is selected, you can use the DISPLAY key on the

main unit or the remote control to switch whether its video

is shown on the iPod itself or output through this unit’s

VIDEO OUT jack.

You cannot, however, switch the video output destination

during video playback. Switch it while the iPod is stopped

or stop the playback once and then switch it if the iPod is

already playing back.

If switched during video playback, the new output

destination is used when playback is stopped then started

again.

[Video Out: iPod]

[Video Out: CD-200i VIDEO OUT]

When VIDEO ON is selected, the iPod video signal is

•

always transmitted from this unit’s video outputs,

regardless of the selected (audio) output source.

When playing the video clip by iPod Touch, pressing

•

the DISPLAY key stops the video playback.

5 − iPod Playback

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Tascam CD-200i Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info