Bedienungsanleitung Taurus AC 350 RVKT (Seite 10 von 28) (Englisch, Französisch, Portugiesisch, Spanisch)

727639

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

English

- NOTE: If the temperature of the room is higher of the

selected one, the appliance will not start working.

Fan function:

- Press the button MODE until the word Fan appear on

the control panel.

-You can choose the speed fan: Low-middle-high

Dehumidifying function:

- Press the button MODE until the word Dry appear on

the control panel

- On the dehumidifying mode, the fan is working in low speed.

Anti-freezing protection control

(only for the model AC 350 RVKT):

- Under anti freezing function,the heat light will ash

Anti-heating protecting

(only for the model AC 350 RVKT):

- Under heating mode, the compressor and motor

will stop work until the temperature of the machine

automatically recover to ordinary heating status.

Compressor delay-protection

Except for the rst power-on, the compressor can start

at once. In other cases, the compressor runs under 3

minutes delay protection.

Water tank full protection:

- When the water level in the bottom water plate is above

the warning level, the unit will alert automatically and “FL”

will ashes on LCD.

-Please discharge water in the machine according to

chapter “water drainage”.

Stand-by function:

- In order to save energy, the appliance passes to stand-

by after 10 seconds if the user does not use it.

- To turn it on again, you simply have to press the on/

off button.

Once you have nished using the appliance:

- Stop the appliance by releasing the pressure on the on/

off button.

- Unplug the appliance from the mains.

- Remove the water from the water tank.

- Clean the appliance.

Carry handle/s:

- This appliance has a handle on the side of the body,

which facilitates comfortable transport.

Water drainage:

Manual drainage:

- When the water tank is full and unit stop working, please

shut off the unit and unplug .

- Do not move the model sharply, or the water will split out

from water received plate.

- Use a water container to take water under the water

plug.

- Screw off the water plug and unplug the water blocker,

water will come out the water container.

- Stuff up the water blocker and screw down the water plug.

Continuous drainage:

- Screw off the water plug and unplug the water blocker.

-Use water pipe to connect the water outlet. Lead the pipe

to the outside or washroom.

NOTE: This method can be done only if there is no water

in the water received plate.

-This model have self evaporative function, under cooling

mode, please do not use continue drainage to get better

cooling effect.

Cleaning

- Disconnect the appliance from the mains and allow it to cool

before undertaking any cleaning task.

- Clean the electrical equipment and the mains connection

with a damp cloth and dry. DO NOT IMMERSE IN WATER

OR ANY OTHER LIQUID.

- Clean the equipment with a damp cloth with a few drops of

washing-up liquid and then dry.

- Do not use solvents, or products with an acid or base pH

such as bleach, or abrasive products, for cleaning the ap-

pliance.

- Do not let water or any other liquid get into the air vents to

avoid damage to the inner parts of the appliance.

- Never submerge the appliance in water or any other liquid or

place it under running water.

- If the appliance is not in good condition of cleanliness, its

surface may degrade and inexorably affect the duration of the

appliance’s useful life and could become unsafe to use.

Air lter cleaning

- Clean the air lters every 2 weeks. If the air lter is

blocked with dust, the efciency will reduce.

- Pull out up and down lter as below pictures

- Wash the air lters by immersing it gently into warm wa-

ter with a neutral detergent, rinse it and dry it thoroughly

in a shaded place.

- Install air lters carefully after cleaning the lters.

After Season Maintenance:

- Pull out the plug in drainage hole and empty the water

received plate, or drain out the water by leaning the unit,

then shift the unit mode to Fan mode, and press the but-

ton for 5 seconds till it low fan speed.

-Keep this mode for half day till the conduit is dried. Doing

like this can keep the inner unit dried and not go moldy.

- Turn off the unit and pull out the plug.

- Coil the wire and bind it together, then put it into the

accessories room.

- Separate the air-exhausted pipe and safely keep it.

- Put the unit into a plastic bag, then keep it in a dried

place.

- Take out the batteries of remote control and safely keep

them.

* All accessories can be put in the accessories room on

the back of the unit.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Taurus AC 350 RVKT Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info