Bedienungsanleitung Taurus NEW MIXO (Seite 3 von 4) (Spanisch)

729997

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

World time alarm clock

Instruction Manual

General Warnings

RISK OF CHOKING! Keep packaging material, like plastic bags and rubber bands, out of the reach

of children, as these materials pose a choking hazard.

RISK OF ELECTRIC SHOCK!

This device contains electronic components that operate via a power

source (batteries). Children should only use the device under adult supervision. Only use the device

as described in the manual; otherwise, you run the risk of an electric shock.

RISK OF CHEMICAL BURN!!

Leaking battery acid can lead to chemical burns. Avoid contact of

battery acid with skin, eyes and mucous membranes. In the event of contact, rinse the affected

region immediately with a plenty of water and seek medical attention.

RISK OF FIRE/EXPLOSION!

Use only the recommended batteries. Do not short-circuit the device or

batteries, or throw them into a fire. Excessive heat or improper handling could trigger a short-circuit,

a fire or an explosion.

NOTE!

Do not disassemble the device. In the event of a defect, please contact your dealer. The dealer will

contact the Service Centre and can send the device in to be repaired, if necessary.

Do not immerse

the unit in water. Do not subject the unit to excessive force, shock, dust, extreme temperature or

high humidity, which may result in malfunction, shorter electronic life span, damaged batteries

and distorted parts.

Use only the recommended batteries. Always replace weak or empty batteries

with a new, complete set of batteries at full capacity. Do not use batteries from different brands or with

different capacities. Remove the batteries from the unit if it has not been used for a long time.

The

manufacturer is not liable for damage related to improperly installed batteries!

SCOPE OF DELIVERY: World time alarm clock, Instruction manual

Required batteries (not included with purchase): 2 pieces of micro batteries (1.5V, type AAA)

1. BUTTONS AND DISPLAY FUNCTIONS

1. FLASHLIGHT button – turn on or off the ashlight

2. SNOOZE/LIGHT button – activate backlight (appx 5 sec) and pause the alarm for 5 min

3. LCD display

4. MODE button – change the display from normal to home time/city or world time/city

5. ALARM button – display alarm time (5sec) and enter alarm setting

6. ALARM slide switch – to on or off the alarm

7. UP/DOWN buttons – to increase/decrease the current set values or to switch cities eastward or

westward

8. LOCK switch – enable or disable all buttons ( except RESET and ALARM )

9. RC ON / OFF / DST slide switch – activate or deactivate radio signal with summer time option

10. WAVE – start / stop the radio reception process manually or to switch between °C and °F

11. RESET – restore factory settings

12. CLOCK – set the time manually

13. Battery compartment

14. LED ashlight

Displays

D1: Normal basic display:

1 2 3

1. Time

2. Date (or alarm time if alarm is on)

3. Day of week

4. Temperature

5. DST - Summer time

6. Signal strength indicator

D2: Home time/city display:

1 2 3

1. Home time display icon

2. Home time

3. Home city

D3: World time/city display:

1 2 3

1. World time/city icon

2. World time

3. Home time

4. World city

2. GETTING STARTED

• Remove the battery door.

• Insert two new AAA size batteries as per the polarity information marked on the battery compart-

ment.

• Replace the battery door.

• Once the battery is installed, the normal segments of the LCD will be shown before entering the

radio controlled time reception mode.

• The RC clock will automatically start scanning for the radio controlled time signal in 8 seconds.

Note: If no display appears on the LCD after inserting the battery, press the “ RESET ” button by

using a metal wire. In some cases, you may not receive the signal immediately. Due to the atmos-

pheric disturbance, the best reception often occurs during nighttime.

3. CLOCK SETTING

3.1 Automatic setting by radio signal reception

• After insertion of batteries, the unit automatically starts to search for the DCF radio controlled

signal, as indicated by the ashing “ signal tower ” icon.

• When the radio signal is received, the time and date will be set automatically.

The signal indicator icon display signal strength in 4 levels:

Signal Towel Strength

1 2 3

No response / no signal

1 2 3

Weak signal quality

1 2 3

Fair signal quality

1 2 3

Excellent signal quality

Notes:

• Everyday at 2:00 am, the unit automatically carries out the synchronization procedure with the

DCF signal to correct any deviations to the exact time.If the attempt is not successful, the

“ signal tower ” icon will disappear from the display, and the unit will automatically attempt

another synchronization at 3:00 am. This procedure is repeated automatically again at 4:00 am

if necessary.

• Each synchronization process will take between 3 to 16 minutes, depending on the signal strength

received. If no signal is detected, the unit will automatically exit the process in 6 minutes.

• Once the unit is synchronized successfully to the DCF signal, the “ signal tower ” icon will be

turned on until 2:00 am of following day.

• The unit also conducts periodic checking of DCF radio signals at 8:00 am,2:00 pm, and 8:00 pm.

Any successful attempts at these hours will lead to the continuous on of “ signal tower ” until

2:00 am of following day.

• To manually start the DCF signal reception, press the WAVE button. User may also cancel the

process by holding the WAVE button.

3.2 Activating / Deactivating radio signal and summer time

1 2 3

1. Move the RC ON/OFF/DST to the RC ON position ( left ) to allow continuous automatic synchroni-

zation with the radio signal.

2. Move the RC ON/OFF/DST to the OFF position ( middle ) to deactivate the automatic synchroni-

zation without summer time.

3 Move the RC ON/OFF/DST to the DST position ( right ) to deactivate the automatic synchroniza-

tion and to activate the summer time.

Users can use these settings to turn off the RC when they are in regions where they cannot or

are not permitted to receive a radio signal. The changeover of summer time will be based on the

manually set time and date, and on cities that implement summer time.

Taurus NEW MIXO Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info