BP Smart Battery Charger User Manual V1.1
Figure 3.1 installation guide for connecting BC and batteries
Mounting: Mount the battery charger on a vertical surface, using the mounting holes provided.
Mounting hardware should be corrosion resistant. Recommend to use all four mounting
holes.
Connecting DC Wiring for Batteries
WARNING
All the batteries you are charging must be the same type, that is, should be all flooded,
or gel, or AGM.
Plan the route the DC wires will follow trying to make it as short as possible.
Install the DC circuit breaker or fuses in the battery positive circuits close to the battery.
Fully insert each positive wire into the positive terminal on the charger. Tighten the
connector and test that the wire is secure.
Connect the positive cable from the positive wire terminals on the charger to the battery
fuse or breaker, which should be installed on the battery positive terminals. Leave the DC
disconnects or breakers in the OFF position until installation is complete. Leaving them off
helps prevent sparking when you actually make the connection.
Connect AC Wiring
TBB Power Co. Ltd. 10
