11
MIC STAND MOUNTING
7. Your VoiceSoloXT should now look like this.
Adjusting the Boom
To optimize line-of-sight and audibility it is usually better to
have the monitor situated somewhat beside the singer. To
do this it is necessary to adjust the position of the boom.
The steps required to adjust the position of the boom are
as follows:
1.With the VoiceSoloXT integrated into the mic stand and
boom, loosen the boom by rotating to the right while
holding onto a corner of VoiceSoloXT.
2. Still holding the boom so that it does not swing away,
turn the lock nut counter-clockwise until it’s snug against
the bottom of the boom. Note that it’s not possible to
completely tighten the lock nut with your fingers, the final
action is done by swinging the boom snug against the
lock nut.
3. After tightening the lock nut with your fingers, swing the
boom left, tightening to the desired position. It may be
necessary to go through steps 1 - 3 a few times to get
the boom tightly where you want it. The boom must be
tight or the weight of the mic can cause it to swing out of
position.
Read the next section to learn how to connect your cables
and power up VoiceSoloXT.
