19
For Advanced Users
can tap the Tone button to cycle through the numbered
choices shown below:
d: Default setting best for most situations
1: Choose this if you have a very bright-sounding PA
2: This option adds “warmth” to your voice
3: Increased compression. Caution: this slightly
increases the likelihood of feedback
Hold the Tone button to exit. Toggling the Tone button
will now activate your alternate choice.
Changing the Number of Presets
The default configuration of Harmony-M is to offer five
presets each having an A and B setting. When using the
Preset select mode this allows you to cycle through five
presets with a reasonable number of footswitch or Preset
button pushes. If you want access to more presets and are
willing to step through more than five, or would like to
reduce the number so you can cycle through three favorites
for example, there is a way to set this in Harmony-M.
To set the accessible number of presets, power up
holding the Preset button. After a moment, the number
“5“ will show the default number of presets. Tap the
Preset button to extend the limit to up to ten (shown as
“0”) or down to three (1 and 2 are not options). Hold
the Preset button to store this setting and exit to normal
operation. Note that the extra presets are not pre-
programmed so you can build your own.
External Mixing with Mono and Dry Outputs
If you prefer, you can leave the level balancing between
your dry voice (Tone active only) and a 100% wet, mono
signal of the Harmony, Double and FX to your sound
engineer. Ensure the Stereo LED is not lit then connect
the outputs to two channels of your audio mixer. The
Left Out will be the wet effects and the Right Out will
be your dry voice. These can be adjusted as needed by
your sound engineer.The Harmony control should be set
to its full right position in this output scheme.
