START OF SEASON
If the air conditioner is to be used again after an extended period:
• Check that the air intake and exhaust openings of the interior and exterior units are
not blocked. Remove all dirt and debris.
• Check that filter is installed and is clean.
• Check that the condensation outlet drains properly and there is no dirt or organic blockage
(otherwise leakage may occur)
• Install 2 AAA batteries in the remote control.
• Turn the appliance on, set the time and desired setting.
REPLACING THE BATTERIES
• Remove the remote cover.
• Replace the AAA batteries, ensuring the correct polarity.
• Install the cover.
• Press the on/off button; if no symbols appear on the display, the
batteries require replacing or have been incorrectly installed.
INSTALLATION GUIDE
SAFETY
Only qualified personnel should install this appliance. This installation manual is intended for
use by individuals possessing adequate backgrounds and qualifications in electrical,
electronic, refrigerant and mechanical field. Any attempt to install or repair the appliance may
result in personal injury and property damage.
The manufacturer or seller cannot be responsible for the interpretation of this information, nor
can it assume any liability in connection with its use.
The units are designed for permanent installation.
The equipment is designed for domestic or office use and we are not making any
endorsements for use in industrial or maritime environment.
Do not place near sources of heat, vapors, industrial machine oil or other flammable gases.
High-frequency waves generated by radio equipment, welders and medical equipment will
interfere with the normal operation of the unit.
Install this device only when it complies with local/national legislation, ordinances and
standards.
Check the mains voltage and frequency. This unit is only suitable for an earthed electrical
supply, connection voltage 230 V~ / 50 Hz. The information, specifications and parameter
are subject to change due to technical modifications or improvement without any prior notice.
The accurate specifications are presented on the nameplate label.
Please read this installation manual completely before installing the product.
When the power cord is damaged, replacement work shall be performed by authorized
personnel only.
Installation work must be performed in accordance with all European, national and / or local
directives and standards and must be done by authorized personnel only.
Always make sure to wear the correct personal safety protections such as protective
eyewear, gloves, ear protection etc.
