Bedienungsanleitung TCL LE43FHDF3300 (Seite 11 von 26) (Englisch)

794243

Zoom out

Zoom in

Vorherige Seite

1/26

Nächste Seite

ANT/CABLE

/SAT IN

Outdoor or indoor Antenna

Cable Box,

( Wall Outlet)

RF Coaxial

Wire

(75 ohm)

Connections and Setup

Obtain the Signal

The rst step in connecting your TV is obtaining the signal. The back panel of your TV allows you to receive

analog and/or digital channels by using the ANT/CABLE/SAT IN.

Connect the outside aerial or cable network to the

ANT/CABLE/SAT IN on the back of the TV set to

receive off-air channels or cable channnels.

• If you have a set-top box, you may need to call your

cable company or satellite service provider. They may

recommend special cables to allow you to view digital

channels.

• The aerial socket (75 OHM - VHF / UHF / cable) can be

used for connecting an external aerial or other equipment

tted with a modulator (video recorder, satellite receiver, etc.).

We recommend that you do not connect other equipment

(video recorder, satellite receiver, etc.) to your TV set to

begin with, so as not to complicate the set-up procedure

with the additional steps involved. Connect them when

you have nished setting up the channels.

• Visit www.antennaweb.org for help in deciding what type of antenna to use in order to receive the local

digital channels available to you. Enter your location, and the program will list local analog and digital

stations available using your antenna.

Switching On

Follow the instructions on this page on how to switch on your TV set and use the remote control before going

on to following pages describing how to use the channel scan procedure.

1. Insert two AAA batteries in the remote control.

Precautions on using batteries:

- Only use the battery types specied.

- Make sure you use the correct polarity.

- Do not mix new and used batteries.

- Do not use rechargeable batteries.

- Do not expose batteries to excessive heat such as sunshine, re or the like, throw them in a re, recharge

them or try to open them, as this could cause them to leak or explode.

- Remove the batteries from the remote control if you are not using it for a long period of time.

2. Connect the power cable to a mains socket. (If the power cable is not connected to the television, please

rst connect the power cable to the television.) Your TV set should only be connected to an AC supply.

It must not be connected to a DC supply. If the plug is detached from the cable, do not, under any

circumstances, connect it to a mains socket, as there is a risk of electric shock.

3. When powered on, if the TV set is in standby mode, press on the remote control or on the TV set to turn

on the TV.

Switching Off

To put the TV set into standby mode, press on the remote control or on the TV, the TV set remains

powered up, but with low energy consumption.

To switch off the TV set, unplug the mains socket from the mains outlet.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

TCL LE43FHDF3300 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info