Bedienungsanleitung Team EXP 155 (Seite 17 von 48) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

486862

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

        

language integrity.

Assembly page 17/48

Fax +32 2 359 95 50

Creamer disk: Separate both parts and wipe them under hot water before assembling them.

Drip tray: In order to clean the drip tray, remove the tray and the grid.

CAUTION: NEVER TRY TO OPEN OR TO DISASSEMBLE THE BODY OF THE APPLIANCE.

DESCALING

The expresso machine has to be descaled regularly. The frequency depends on the water

hardness and of the use frequency.

1. Remove the scale and the coffee residues from the filter grid and from the support of the

filter holder. It is recommended to use only liquid descaling agent that can be found in

shops and in the proportions indicated on the packing paper by the producer.

2. Place the container under the support of the filter holder and another one under the

steam pipe (9) (Caution: do not use the filter holder (12) during the descaling).

3. Press the ON Switch (5), turn the steam control knob (17) in the open position, and press

the expresso button . Wait until steam comes out the opening of the pipe (9).

4. After approximatively 30 seconds, stop the hot water flow by closing the steam control

knob (17) and let the descaling solution flow through the support of the filter holder in the

container.

5. When the solution has finished flowing, switch off the appliance and let it cool down.

6. Repeat this operation a second time.

Then proceed in the same way but this time only with fresh water to rinse the inner side of the

circuit. For a good rinsing, the equivalent of two expresso tanks has to pass through the circuit.

Switch off the appliance and remove the plug from the power supply. Let it cool down.

Attention: Never use vinegar as descaling agent.

Some recognizable signs indicate that descaling is necessary:

 Increase of the noise during boiling.

 A longer time of decoction cycle

For a regular use, the descaling has to be done in the following periodicity:

 With little bit hard water, once a year

 With middle hard water, once a trimester

 With hard water, once a month.

In case of doubt concerning the water quality, ask your local water company.

PROBLEMS AND CAUSES OF THE NON FUNCTIONING OF THE EXPRESSO

PROBLEMS

CAUSES

No hot water

-Check that there is water in the water tank

-Open the control knob (17) after having placed a container

under the steam pipe (9) and press the expresso button to

remove the air in the hydraulic circuit. When water comes out of

the steam pipe (9), close the tap (17) and press the expresso

button again.

-If those solutions are not enough, please ask to the competent

customer service.

No steam

-Clean every residue in the steam pipe with a needle.

-Check that there is water in the water tank

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team EXP 155 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info