Bedienungsanleitung Team ft 5 (Seite 10 von 40) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

363489

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

the I/B. Don‟t change the page numbering. Keep the

language integrity.

10 TEAM FT 5 - 060131

Assembly page 10/40

Fax +32 2 359 95 50

again to switch on the appliance again. Once all the fat has melted, set the temperature

knob to the desired cooking temperature. This type of fat will solidify when the appliance

cools down.

(*)

Competent qualified electrician: after sales department of the producer or importer or any

person who is qualified, approved and competent to perform this kind of repairs in order to

avoid all danger. In any case you should return the appliance to this electrician.

BEFORE USE

 When the fryer is new, the force of the lid spring is quite strong. After the fryer has been

used 10-15 times the spring force will reduce. This is quite normal.

 Remove all packaging from the unit.

 Before you use the deep fat fryer for the first time, we recommend that you clean the lid,

bowl, basket, handle and jacket of the deep fat fryer with warm soapy water with a soft

cloth. This will remove any residue left from the manufacture of this unit. See "Cleaning"

section.

DISASSEMBLING THE DEEP FAT FRYER

 Stand the appliance on a dry horizontal surface.

 Open the lid by pressing its opening button, raise it and detach it by pulling at it when it is

in vertical position.

 Raise the handle and remove the basket.

 The bowl can also be removed to facilitate cleaning. Caution: wait until the oil or the

grease has totally cooled down before taking the bowl out of the appliance. If you are

using grease, use a plastic or wooden spatula to remove it in order not to damage the

coating of the bowl.

ASSEMBLING THE DEEP FAT FRYER

 Stand the appliance on a dry horizontal surface.

 Insert the bowl correctly in the appliance. If the bowl is not placed correctly, the

appliance will not work properly.

 Place the handle into the slot on the front of the fryer. Pull the handle release button

towards you and swing the handle down. This will allow you to lower the basket

completely into the bowl. To raise the basket, proceed inversely.

 Hold the lid vertically and place the wire spring into the slot at the back of the fryer. Close

the lid.

 Wind any excess cable on the cord storage hooks area on the back of the unit.

FIRST USE

 When using the appliance for the first time, pour the required amount of oil in the bowl,

making sure that the level is between the MIN and MAX marks indicated inside the bowl.

 We recommend that you use exclusively a liquid oil that is suitable for deep fat frying.

Check the label on the bottle. If you wish to use a solid fat, cut the fat in small pieces. Plug

in the appliance, turn the timer knob to switch on the appliance, put the thermostat on

the lowest position and add the fat pieces slowly. When the fat has melted, set the

thermostat to the desired temperature. WARNING: FAILURE TO OBSERVE THIS WILL DAMAGE

YOUR DEEP FAT FRYER.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team ft 5 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info