Bedienungsanleitung Team RS 1 (Seite 10 von 32) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487222

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced

and folded in order to obtain a booklet A5 (+/- 148.5 mm

width x 210 mm height). When folding, make sure you

keep the good numbering when you turn the pages of

the I/B. Don’t change the page numbering. Keep the

language integrity.

10 TEAM RS 1 070228

Assembly page 10/32

Fax +32 2 359 95 50

TECHNICAL SPECIFICATIONS OF THE CHARGER

Your appliance is delivered with an adaptor, and if you have to replace it, we advise you to

call in for the nearest customer service or, in case of emergency, to pay attention to the

following characteristics:

- Voltage: make sure to respect the voltage of the country you are using the

appliance in.

- Voltage supplied: 9Vdc

- Current intensity: 300mA

We do not accept any liability for damages resulting from non-observance of this paragraph

CHARGING PROCESS

Do not charge your appliance if the room temperature is below 0°C or above 40°C.

Never charge your appliance more than 20 hours.

We advise you to charge your appliance fully (about 8 to 10 hours) before the first use and to

let it discharge itself regularly afterwards in order to increase the battery's lifespan. When you

do not use the appliance for a long time, it is perfectly normal that the battery discharges itself.

Insert the adapter's end into the unit, then plug into an electrical outlet. The charging indicator

on top of the appliance illuminates.

If you use another adapter than the one supplied, make sure it possesses the same

characteristics as mentioned above.

ASSEMBLY

 Put the main body of the sweeper on the floor.

 Insert the connection nozzle in the opening foreseen for that purpose on the body of the

appliance (Fig. 1, p. 4).

 Assemble the tubes and attach the handle to the upper end of the tubes (Fig. 2, p. 4).

 Insert the other lower end of the tubes to the connection nozzle.

 The appliance is now ready for use.

USE OF THE APPLIANCE

 Make sure the dust collector is installed properly in the main body before switching on the

appliance.

 Check the dust level of the dust collector before each use and if it is full, empty it before

use.

 Hold the appliance by the handle and switch it on by pressing the on/off switch with your

hand of foot (Fig. 3, p. 4).

 To switch off the appliance, press the switch again.

 Thanks to the 360° swivel system of the connection nozzle of the appliance, you can reach

even the places that are hard to reach.

 If you want to, you can also use only one part of the tube, as the handle can be attached

to any of the tube parts. This will allow cleaning places that are hard to reach (e.g. under

a bed).

MAINTENANCE

Put the switch in OFF position and unplug the appliance from its charger before starting any

maintenance operation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team RS 1 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info