Bedienungsanleitung Team SIS 3 (Seite 14 von 48) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487279

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don‟t change

the page numbering. Keep the language integrity.

Assembly page 14/48

Fax +32 2 359 95 50

 During ironing this pilot light (3) will come on from time to time. When this happens, the

soleplate is being heated-up to the required temperature again. You can continue

ironing.

 The table is valid for the fibre materials only. If some kind of finish has been applied (gloss,

wrinkle, relief etc), the textile can best be ironed at a lower temperature.

First sort out the fabrics according to ironing temperature: wool with wool, cotton with

cotton, etc.

The iron heats up quicker than it cools down. Therefore, start ironing the articles requiring

the lowest temperature such as those make of synthetic fibres. Then progress to the higher

temperatures.

 If the article is made of a mixture of different fibre, you must always select the lowest

ironing temperature of the composition of those fibres.

(E.g. an article consisting of “60% polyester and 40% cotton” should be ironed at the

temperature indicated for polyester and without steam).

If you do not know what kind(s) of fabric(s) the article has been made of, find a spot,

which will be invisible when wearing or using the article to try out the ironing temperature.

(Always start at a low temperature and increase to one, which gives the required results).

 Pure woollen fabrics (100% wool) may be pressed with the iron set to a steam position. It is

recommended to apply shot-of-steam and use a dry pressing cloth.

When steam-ironing woollen fabrics, shining of the fabric may occur. This can be

prevented by turning the article inside out and ironing the inside or by interposing a light

damp cloth.

 Velvet and other textures that rapidly acquire shiny spots should be ironed in one direction

only (with the nap), applying only light pressure.

Always keep the iron moving.

 Iron the reverse side of synthetic materials and silk, it is not advisable to use steam as this

may cause stains.

FILLING WITH WATER (FOR STEAM-IRONING)

1. Put the base on a stable surface.

2. Open the cap of the water tank and fill it with clear water up to its "Max" level. You can

use tap water, but we advise you to use demineralised water.

3. Close the cap of the water tank

4. You can detach the water tank by lifting it, and then fill it as described by steps 2 and 3

above.

5. Put the water tank back in the base correctly. Caution, if the water tank is not positioned

correctly, a safety device will prevent the pump from operating and as a result, it will

prevent the steam production. If this happens, check whether the water tank is placed

correctly on the base.

6. Never use vinegar, detergents or other chemical products.

Caution: always make sure that the anti-scale cartridge situated underneath the water tank is

well into place. Never use the appliance without anti-scale cartridge.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team SIS 3 Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info