Bedienungsanleitung Team SIS 9 (Seite 11 von 40) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487285

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don‟t change

the page numbering. Keep the language integrity.

11 TEAM SIS 9 - 071121

Assembly page 11/40

Fax +32 2 359 95 50

 NEVER UNSCREW THE CAP OF THE STEAM TANK WHILE THE APPLIANCE IS CONNECTED TO THE

MAINS WALL SOCKET AND ESPECIALLY WHEN STEAM IS BEING PRODUCED.

 Always place the iron on the base of the appliance, on the therefore foreseen place. Do

not place iron by its rear cover. Be sure that it doesn‟t come in contact with flammable

materials or with the mains cord.

 Never fill the steam tank with vinegar, descaling agents or other chemicals.

 Before using for the first time remove any sticker or protective foil from the soleplate. Clean

the soleplate with a soft cloth.

 Some parts of the iron have been slightly greased and as a result the iron might slightly

smoke when switched on for the first time. After a short while, however, this will cease.

 The iron shall be used and placed on a stable level surface.

 Do not use the iron if it has fallen, if it shows any visible signs of damage or if it leaks.

 When you place the iron on its support (if available with the model), make sure that the

surface on which you put it is stable.

(*)

Competent qualified service: after sales department of the producer or importer or any

person who is qualified, approved and competent to perform this kind of repairs in order to

avoid all danger. In any case you should return the appliance to this service.

STEAM IRON: USE PRECAUTION AND TEMPERATURES

 Always check first if a label with ironing instructions is attached to the article to be ironed.

Follow these ironing instructions in all cases.

 If ironing instructions are missing but you know the kind of fabric, then see the table for

recommended ironing temperatures.

 As soon as you plug in the appliance, the iron is switched on, even if you haven't

activated the water tank's switch. Turn the thermostat (4) to the desired position. The pilot

light (6) of the iron will come on. As soon as the desired temperature is reached, the pilot

light (6) goes out.

 During ironing this pilot light will come on from time to time. When this happens, the

soleplate is being heated-up to the required temperature again. You can continue

ironing.

 The table is valid for the fibre materials only. If some kind of finish has been applied (gloss,

wrinkle, relief etc), the textile can best be ironed at a lower temperature. First sort out the

fabrics according to ironing temperature: wool with wool, cotton with cotton, etc.

Kind of textile

Temperature dial

Steam ironing

Synthetic (e.g. acetate,

acrylic, viscose,

Polyamide, polyester, ….)

Silk

MIN



Wool



YES

Cotton

Linen



MAX

YES

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team SIS 9 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Team SIS 9

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info