Bedienungsanleitung Team ST 15 ET (Seite 15 von 39) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487309

Zoom out

Zoom in

Vorherige Seite

1/39

Nächste Seite

Generated by Unregistered Batch DOC TO PDF Converter

2011.3.804.1511, please register!

Copies of the I/B. Please reproduce them without any changes

except under special instruction from Team International

BELGIUM. The page must be reproduced and folded in order to

obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). The

pages must be folded in order to keep the good numbering



numbering. Keep the language integrity.

15 TEAM ST 15 ET - 070615

Assembly page 15/39



EMPTYING THE DUST CONTAINER

 Press the unlock buttons on the sides of the front part of the dust container and

simultaneously remove the container (Fig. 6)

 Press the unlock button at the bottom of the dust container (Fig. 7). Open the bottom of

the container and empty it. This should be made above a dustbin.

 Close the container.

FILTERS

This device is equipped with a HEPA filter and a nylon filter situated in the dust container, and

an air filter situated behind the grid of the appliance.

Cleaning the HEPA fliter and the nylon filter

If the suction power is reduced even after emptying the dust container, it is necessary to clean

the HEPA filter and the nylon filter.

 Remove the dust container as mentioned here above.

 Turn the superior front part of the container anticlockwise until it comes off.

 Remove the front part and the dust container filters.

 Remove the front part filters of the container by making it turn anticlockwise (Fig. 8)

 The nylon filter is situated around the HEPA filter, to remove it, you just have to pull it out.

 Rinse the HEPA filter and the nylon filter with water. If necessary, you may use a smooth

brush. Carefully dry the filters. Never put them in a dishwasher or dry them with a hair

dryer.

 To put back the filters, do it the opposite way.

Cleaning of the air filter

The air filter is situated behind the grid at the back of the appliance and guarantees fresh air

when vacuum cleaning. This filter should be cleaned approximately three times a year.

Plug the appliance out, open the grid situated at the back of the appliance and remove the

filter (Fig. 9). Shake it, then put it back in the appliance and close the grid.

NOTE: After a certain number of cleanings the filters will be damaged or impossible to get back

in their initial shape. In such case, please contact the nearest customer service to obtain new

filters.

Cleaning of the dust container

Clean the dust container with a wet towel or a non- abrasive sponge. Make sure it is fully dry

before putting it back into the appliance.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team ST 15 ET Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info