Bedienungsanleitung Team ST 18 ET (Seite 8 von 28) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487312

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don‟t change

the page numbering. Keep the language integrity.

8 TEAM ST 18 ET - 090904

Assembly page 8/28

Fax +32 2 359 95 50

ASSEMBLING THE VACUUM CLEANER

 Always remove the plug from the power socket before fitting or removing accessories!

 Insert the hose connector into the hose connection inlet until it locks. To remove the hose,

press the sides of the hose connector and pull at the hose.

 Fit the tube to the handle.

 Fit the tube to the floor brush.

 Removing telescopic tube and accessories: to remove the accessories, pull firmly apart.

 The floor brush is ideal for the daily cleaning of carpets and hard floors.

Setting with the bristles inside for cleaning carpets.

Setting with the bristles outside for cleaning hard floors.

 The appliance is delivered with the following accessories:

 a crevice tool: for radiators, crevices, corners, baseboards

and between cushions.

 an upholstery brush: for curtains, cushions, edges, doors,

mattresses etc.

OPERATION

 Pull out a sufficient length of power cord and insert the plug into the power socket. A

yellow mark on the power cable shows the ideal cable length. Do not extend the cable

beyond the red mark. Switch on the appliance by pressing the ON/OFF switch with your

foot.

 It is advisable to set the electronic power regulator to MIN before switching on the

appliance. By turning the regulator button, the suction power can be adjusted. You can

also adjust the suction power by using the wind-force adjuster on the handle. Use a low

suction power for furniture and other delicate surfaces and use high suction power for

fitted carpet and other floors.

AFTER USE

 Stop the vacuum cleaner by pressing the ON/OFF switch.

 Unplug the appliance from the power supply.

 Simply press the cable rewind button to activate the cable rewind mechanism.

REPLACING THE DUST BAG AND CLEANING THE FILTERS

Filters

The filter system consists of: 1 motor filter (in front of the motor in the dust compartment)

1 air filter, to vacuum the smallest particles (on top of the motor in

the dust compartment)

It is necessary to clean the filters regularly to avoid operating problems.

Paper dust bag

 The dust bag level indicator indicates when the dust bag should be replaced.

 The hose might get blocked by a larger object. In this case the dust bag level indicator will

be red. However this does not mean that you have to replace the dust bag. Just remove

the object which blocks your tube or flexible hose, and your appliance will function

properly again. Do not forget to unplug the appliance before removing the blocking

object. Replace the dust bag when the dust bag level indicator is completely red.

 Disconnect the hose.

 Open the dust compartment.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team ST 18 ET Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info