Bedienungsanleitung Team ST 28EC (Seite 12 von 32) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487324

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Generated by Unregistered Batch DOC TO PDF Converter

2011.3.804.1511, please register!

Copies of the I/B. Please reproduce them without any changes

except under special instruction from Team International

BELGIUM. The page must reproduced and folded in order to

obtain a mini booklet B5 (+/- 150 mm width x 210 mm height).

The page must be folded in order to keep the good numbering

when you turn the page of the I/B . Don‟t change the page

numbering. Keep the languages integrity.

Assembly page 12/32

Fax +32 2 359 95 50



UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)

This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp plug is

used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour coded:

blue = neutral, brown = live, green or green & yellow = earth.

The blue wire must be connected to the terminal marked N or coloured in black.

The brown wire must be connected to the terminal marked L or coloured in red.

The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&

yellow).

ASSEMBLING THE VACUUM CLEANER

 Always remove the plug from the power socket before fitting or removing accessories!

 Insert the connection wand into hose connection inlet until it locks by before pressing two

connection buttons on hose connection wand (Fig. 1).

 When removing hose assembly, pull out hose connection wand with pushing down two

connection buttons.

 Fitting the telescopic tube to the handle (Fig. 2).

 Fitting the telescopic tube to the floor brush (Fig. 3).

 You can adjust the length of telescopic tube by pushing the button (Fig. 4).

 Removing telescopic tube and accessories: to remove the accessories, pull firmly apart.

 The floor brush is ideal for the daily cleaning of carpets and hard floors.

Press the lever (A) for cleaning hard floors.

Press the lever (B) for cleaning carpets.

 The appliance is delivered with a crevice tool: for radiators, crevices, corners, baseboards and

between cushions.

OPERATIONS

 Pull out a sufficient of length of power cord and insert the plug into the power socket. A yellow

mark on the power cable shows the ideal cable length. Do not extend the cable beyond the red

mark.

 It is advisable to set the electronic power regulator to MIN before switching the appliance on. By

moving the regulator button, the suction power can be adjusted.

WHEN CLEANING IS FINISHED

 Stop the vacuum cleaner by depressing on the switch button.

 Disconnect plug from electrical outlet

 Simply press lightly with your foot on cable rewind button on top of cleaner.

Replacing the dust bag

 Always operate the cleaner with dust bag installed

 Disconnect from electrical outlet before changing dust bag.

 Lift dust cover catch and raise dust cover.

 Remove bag collar from bag holder and pull out dust bag.

 Put in new dust bag and close the dust cover.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team ST 28EC Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info