Bedienungsanleitung Team ST 29ET (Seite 10 von 31) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487325

Zoom out

Zoom in

Vorherige Seite

1/31

Nächste Seite

Generated by Unregistered Batch DOC TO PDF Converter

2011.3.804.1511, please register!

Copies of the I/B. Please reproduce them without any changes

except under special instruction from Team International BELGIUM.

The page must be reproduced and folded in order to obtain a

booklet A5 (+/- 148.5 mm width x 210 mm height). The page must be

folded in order to keep the good numbering when you turn the page

of the I/B . Don‟t change the page numbering. Keep the language

integrity.

Assembly page 10/31

Fax +32 2 359 95 50



UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)

This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp

plug is used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour

coded:

blue = neutral, brown = live, green or green & yellow = earth.

The blue wire must be connected to the terminal marked N or coloured in black.

The brown wire must be connected to the terminal marked L or coloured in red.

The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&

yellow).

ASSEMBLING THE VACUUM CLEANER

 Always remove the plug from the power socket before fitting or removing accessories!

 Insert the connection wand into hose connection inlet until it locks (Fig. 1).

 Connect both parts of the tube.

 Fitting the telescopic tube to the handle (Fig. 2).

 Fitting the telescopic tube to the floor brush (Fig. 3).

 You can adjust the length of the telescopic tube. Grasp the upper tube in order to read

the text on the locking ring (OPEN-CLOSE) and twist the lower tube from right to left to

loosen the locking ring, then pull the lower half down to the desired length, and then

turning the locking ring from left to right to lock the assembly. For storage of the tube

assembly, reverse the above procedure.

 Removing telescopic tube and accessories: to remove the accessories, pull firmly apart.

 The floor brush is ideal for the daily cleaning of carpets and hard floors.

Press the lever (A) for cleaning carpets.

Press the lever (B) for cleaning hard floors.

 The appliance is delivered with a crevice tool: for radiators, crevices, corners, baseboards

and between cushions.

OPERATIONS

 Pull out a sufficient length of power cord and insert the plug into the power socket. A

yellow mark on the power cable shows the ideal cable length. Do not extend the cable

beyond the red mark.

 It is advisable to set the electronic power regulator to MIN before switching the appliance

on. By moving the regulator button, the suction power can be adjusted.

WHEN CLEANING IS FINISHED

 Stop the vacuum cleaner by depressing on the switch button.

 Disconnect plug from electrical outlet

 Simply press lightly with your foot on cable rewind button on top of cleaner.

REPLACING THE DUST BAG AND CLEANING THE FILTERS

The filter system consists of: 1 Motor filter

1 Air filter, to vacuum the smallest particles

It is necessary to clean the filters regularly to avoid operating problems.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team ST 29ET Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info