Bedienungsanleitung Team ST 31 EC plus (Seite 9 von 28) (Deutsch, Englisch, Holländisch, Französisch, Italienisch, Portugiesisch, Spanisch)

487567

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don‟t change

the page numbering. Keep the language integrity.

Assembly page 9/28

Fax +32 2 359 95 50

UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)

This product must only be used from a 13 amp power socket. If a BS1363 approved 13 amp

plug is used, it should be fitted with a 13 amp fuse. The wires on the power cord are colour

coded:

blue = neutral, brown = live.

The blue wire must be connected to the terminal marked N or coloured in black.

The brown wire must be connected to the terminal marked L or coloured in red.

ASSEMBLING THE VACUUM CLEANER

 Always remove the plug from the power socket before fitting or removing accessories!

 Insert the connection wand into hose connection inlet until it locks (Fig. 1).

 Connect both parts of the tube.

 Fitting the tube to the handle (Fig. 2).

 Fitting the tube to the desired brush (Fig. 3).

 The floor brush is ideal for the daily cleaning of carpets and hard floors. (Fig 4)

Press the lever (A) for cleaning hard floors.

Press the lever (B) for cleaning carpets.

 The appliance is delivered with a shoulder strap and a small brush for furniture, Venetian

blinds, books, lamp shades and shelves.

OPERATION

 Pull out a sufficient length of power cord and insert the plug into the power socket. A

yellow mark on the power cable shows the ideal cable length. Do not extend the cable

beyond the red mark.

 It is advisable to set the electronic power regulator to MIN before switching the appliance

on. By turning the regulator button, the suction power can be adjusted. Use a low suction

power for furniture and other delicate surfaces and use high suction power for fitted

carpet and other floors.

AFTER USE

 Stop the vacuum cleaner by pressing the ON/OFF switch.

 Unplug the appliance from the power supply.

 Simply press the carrying handle down to activate the cable rewind mechanism.

REPLACING THE DUST BAG AND CLEANING THE FILTERS

The filter system consists of: 1 Motor filter

1 Air filter, to vacuum the smallest particles

It is necessary to clean the filters regularly to avoid operating problems.

Paper dust bag

 The dust bag level indicator indicates when the dust bag should be replaced.

 The hose might get blocked by a larger object. In this case the dust bag level indicator

will be red. However this does not mean that you have to replace the dust bag. Just

remove the object, which blocks your tube or flexible hose, and your appliance will

function properly again. Do not forget to unplug the appliance before removing the

blocking object. Replace the dust bag when the dust bag level indicator is completely

red.

 Remove the hose from the hose connexion inlet.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team ST 31 EC plus Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info