Bedienungsanleitung Team ST 40 (Seite 5 von 18) (Englisch, Französisch, Portugiesisch, Spanisch)

487577

Zoom out

Zoom in

Vorherige Seite

1/18

Nächste Seite



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don’t change

the page numbering. Keep the language integrity.

5 TEAM ST 40 - 070523

Assembly page 5/18

Fax +32 2 359 95 50

ASSEMBLING THE VACUUM CLEANER

 Always remove the plug from the power socket before fitting or removing accessories!

 Insert the hose connector into hose connection inlet until it locks. To remove the hose,

press the sides of the hose connector and pull at the hose.

 Fit the tube to the handle.

 Fit the tube to the floor brush.

 Removing tube and accessories: to remove the accessories, pull firmly apart.

 The floor brush is ideal for the daily cleaning of carpets and hard floors.

Setting with the bristles inside for cleaning carpets.

Setting with the bristles outside for cleaning hard floors.

OPERATIONS

 Pull out a sufficient length of power cord and insert the plug into the power socket. A

yellow mark on the power cable shows the ideal cable length. Do not extend the cable

beyond the red mark. Switch on the appliance by pressing the ON/OFF switch with your

foot.

 With the supplied accessory you can clean surfaces that are hard to reach, such as

furniture (use the crevice tool) and delicate surfaces such as curtains (use the small brush).

This accessory can be mounted on the handle or on the tube.

AFTER USE

 Stop the vacuum cleaner by pressing the ON/OFF switch.

 Unplug the appliance from the power supply.

 Simply press the cable rewind button to activate the cable rewind mechanism.

REPLACING THE DUST BAG AND CLEANING THE FILTERS

Motor filter

The motor filter is situated in front of the motor. To clean it (approximately every 3 months),

unplug the appliance, open the dust compartment and remove the filter to wash it in

soapsuds and rinse it. When it is completely dry, put it back in the appliance.

Air Filter

 This air filter (situated under the protection grid on the back of the appliance) guarantees

fresh air during cleaning. It should be replaced approximately every 3 months (depending

on the operation frequency)

 To clean it, unplug the appliance, open the protection grid, remove the filter, clean it in

soapsuds and rinse it. When it is dry, put it back and close back the protection grid.

NOTE: After a certain number of cleanings the filters will be damaged or impossible to get back

in their initial shape. In such case you will have to replace them.

Paper dust bag (swirl Y101)

 The dust bag level indicator indicates when the dust bag should be replaced.

 The hose might get blocked by a larger object. In this case the dust bag level indicator will

be red. However this does not mean that you have to replace the dust bag. Just remove

the object, which blocks your tube or flexible hose, and your appliance will function

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Team ST 40 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info